How to program garage door opener on Accord EX V6?

Question:
I just bought a used 2004 Honda Accord EX V6 and it didn't come with a manual, so I'm curious how I can program the garage door opener installed on the vehicle? Does anyone know? Thanks in advance.

Answers:

ALPINE SWX-1242D. can they be ported?

I did as best I could to reproduce the instructions from the Accord Owners Manual. The system is called "Homelink" in the manual. there are two procedures to program the remote; the first works in 90% of the cases.

How do I install a new speaker system (rear deck -front door) in my 1991 Chevy Beretta step by step?

To start, erase any stored codes-- press and hold the two
outside buttons on the HomeLink
transceiver for about 20 seconds,
until the red indicator flashes.
Release the buttons, then proceed as follows

Subs For Dodge Dakota?

Unplug the garage door opener
motor from the electrical outlet.

Anyone know of a good running 235 6 cylinder Chevrolet engine for sale? With or without powerglide.?

Hold the end of the garage door
opener remote 2 to 5 inches from
HomeLink. Make sure you are not
blocking your view of the red
indicator in HomeLink. (the ignition for the car may have to be turned on; it doesn't say if it does or not)

Where is the iat sensor on a peugeot 106 please ?

Press and hold the remote
transmitter button and one of the
HomeLink buttons at the same
time. While continuing to hold the
HomeLink button, press and
release the remote transmitter
button every 2 seconds.

2001 mitsubishi eclipse revs really high and stalls at 40mph and 60mph need help?

If the red indicator in HomeLink
begins to flash slowly at first,
then rapidly, release both
buttons,

Is it worth learning to drive 5-speed manual?

Plug in the garage door opener
motor, then test the HomeLink
button by pushing it for about 1
second.

Is the GM 3100V6 engine eqipped with a timing chain or belt?

If the button works,
programming is complete.

I am looking for a jeep tj hardtop but i dont want to pay 2000 for it where should i get one?

If the button does not work, you
have a rolling code transmitter:

Anyone else not happy with the new Camaro?

‘‘Training with a Rolling
Code System

I just bought a 93 Ford Thunderbird LX and the instrument panel lights don't work.?

Find the ‘‘training’’ button on your
garage door opener unit.
unit. The location will vary, depending on
the manufacturer.
Make sure you have properly
completed the ‘‘Training
HomeLink’’ procedure.
Press the HomeLink button again.
It should operate the garage door.
The ‘‘Training HomeLink’’
procedure trains HomeLink to the
proper garage door opener code.
The following procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.
Press the training button on the
garage door opener unit until the
indicator next to the button comes
on. The indicator may blink, or
come on and stay on. You then
have approximately 30 seconds to
complete the following steps.
Press and hold the button on
HomeLink for 3 to 4 seconds.
Press and hold the HomeLink
button again for 3 to 4 seconds.
This should turn off the training
indicator on the garage door
opener unit. (Some systems may
require you to press the button up
to three times.)

---

More Questions & Answers ...

Print gauge cluster?

What is the degree of difficulty for changing spark plugs for '00 Maxima?

Which is better porsche boxter 99 or mazda mx5 99?

What do you need to chage the front end of a 1993 Nissan 240sx to a "97" S14 Kouki?

1967 Camaro RS?

I just bought a 2007 scion tc should it have come with the jack to play the mp3 player.?

What is the highest speed the Honda Civic 2006 or 2007 have?

Anybody had any problems with the new style Renault Clio's?

I want to buy a powerful BINOCULAR in budget of Rs 1500-2000.can anybody tell me about this.?

What kind of car is this?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.