1995 Monte Carlo, 3.1, 6 cylinder...intake manifold gaskets...with or without push rod guides?

Question:
Do I need with or without push rod guides on intake manifold gaskets? How do I find out? Autozone man didn't know which either, both show up for it. Please help. 1995 Chevrolet Monte Carlo( 3.1) 6 cylinder.

Answers:

best perfomance parts for a 1997 trans am?

look on top of your engine if it says 3.1l MFI you need without guides, if it says 3.1l SFI you need with

---

Can anyone tell me the difference between a Jeep Cherokee Sport and Cherokee Classic?

AS far as I know there are NO push Rod seals or you may be refering to valve stem seals and those require special tools and experience to change you would NOT normally change them during intake manifold gaskets replacement.

---

When does a 1999 Ford Crown Victoria engine start "breaking in"?

Call a Chevy dealership and talk with the service dept. they can tell you and they will know what you are talking about! Autozone don't know anything about anything including the right parts!

---

how to connect the electric choke on a Elderbrock Carb?

I would say with push rod guides. but call chevy parts dept to be sure.

---

More Questions & Answers ...

the heater blower motor resistor where is it located on a chevy astro van?

ford employee discount?

What is the difference between the gas cost of the 2006 mazda3, Toyota Corolla and Honda civic?

My temp gauge rises real quickly while sitting still. Bad thermostat, water pump? 1993 ford tbird 5.0L?

993, 996 or save for a 997? Pukka Porsche all the way... .?

1970 Ford Ranchero GT, 429 Cobra Jet with shaker. Is it rare? If so, how many?

Travelling to Vegas in my Charger.?

99 gmc sonoma is this a good reliable truck?

Where is the Vehicle Speed Sensor(VSS) located?

Just bought a honda cr--v 2005.I dont get it until next monday.i want to purchase alloys for it but what size?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.