Question:
I have recently bought a 78 bay window VW camper and need to replace the driver and passenger rubber door seals as they are perished. Can i do this myself or is it a garage job?
Answers:
Does anyone know the approximate value of a g reg peugeot 205 roland garros?
This is an easy job. Not even a full beer (grin).03' Galant vs. 03' Accord: Which one is better?
1) Order the part.. do NOT remove the old seal until you actually have the right part . You can prob. find it at J.C, Whitney or any of the VW parts houses (google them ).
What starter fits a chevy caviler 99 that i can find in a junk yard?
2) With the part in hand, check it against the in-place part.. these things are great when they are the right part, but a lot of time they send you the wrong one.
3) Got the right part? ok.. pull the old one out.. you may have to cut it to get a starting point. It is usually just held in by compression, but a little bit of rubber cement never hurts.
How do I convert my standard floor shift to a quick shift?
4) Stretch out the rubber and fit it into the channel then compress it back into place. Work your way around the door so that you end up with a uniform seal with no gaps.
Can anyone tell me if an Opel Astra van is taxed Private?
5) DO BOTH SIDES.. yeah,,, the other side is fine, but replace it anyway AFTER you learn how with the other side.
How do I install a new head unit (cd reciever) in my 1999 chevy tracker?
(come to think of it .. maybe this IS a full beer job).
I Have a Lexus ES 300 takes awhile to go into drive.?
.. thats it.. have fun.
Does anybody know where to get an acura integra type-r?
you got a shaggin wagon?AWESOME!!The Jeep Patriot, anyone have one?
Did it on a 67 beetle once and if i remember they were just Glued onExhaust for '97 ford explorer?
pull the old one off and clean off the old gum.re-glue new one on,when fitted sprinkle talcing powder or flour around the seal so it dosent stick when you close the door.
What does manu & p/w mean ? its od da dash board of ma new Rav4?
Like the other guy said, first make sure the new part matches properly.After you get the old seal off, clean off any residue from the old adhesive.
Apply a bead of fresh adhesive (3M makes a very good weatherstrip adhesive. Go with the black.) to the weatherstrip AND to the door where it will fit using an acid brush.
Let the adhesive get tacky, then set the weatherstrip in place. Tape the bottom up against the door if it sags, (use masking tape as not to harm the rubber or your paint) & leave the door open until the adhesive is cured. (You may want to pull the fuse for the interior light as not to run your battery down.)
Brush the new moulding lightly with baby powder before closing the door.
You're done.
Can do yourself as most is glued and there are a few clips the rubber hangs onto in stratigic points. Just get the rubber and you will see the rest.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.