Gear ratio question?

Question:
How do you setup a gear ratio?
drive gear teeth : driven gear teeth
OR
driven gear teeth : drive gear teeth
OR
are both incorrect?

Answers:

Front Hub/Wheel Bearing on 1999 Pontiac Sunfire Question?

It is expressed as the number of revolutions the input shaft makes for one reveloution of the output shaft.

TIG welding on American Chopper / Biker Build-off etc.?

So a ratio of 3.50 would mean that the input shaft will have to rotate 3 and a half times for the output shaft to rotate once.

---

How do you remove a passtime starter interupt device from your car?

Driven divided by driver.

---

Is Shell Gas really cleaner than other gas?

pinion to ring gear and to figure the ratio you divide the ring by the pinion for instance 40 tooth ring divided by 10 tooth pinion =4.10 ratio

---

More Questions & Answers ...

Is it hard to install a K&N FIPK for a 2000 Mercury Grand Marquis?

Which number (position) is the radio fuse in the fuse box of a Honda CRV Y2000?

Labor cost for sparkplugs and crankshaft sensors..?

Trouble starting truck?

How can I remove the front lights cover of my car to replace the lights?

Iat sensor on kia spectra?

ABS light coming on ,car wont start?

I put 10W30 oil in my car. I then found out that it's supposed to have 5W30 oil in it. What should I do?

How much should i pay for a disk brake conversion if i have all of the parts?

1998 dodge 1 Ton when it gets warm it will run rough and on excelleration hesitate then backfire/throutlebody?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.