Question:
Can someone please tell me what how do a car reacts when its time to change the fuel filters?
Answers:
how do you change the brake master cylinder of a 1996 toyota camry?
A fuel filter could be the problem, but it is more likely that you are having an ignition problem, and a plug is either not firing, or firing out of sequence. Change your plugs, make sure your plug wires are going to the correct cylinder, and that they make good contact with the plugs, and make sure your plugs are well connected at the distributor. You may have a bad plug, a bad plug cable, water in the distributor, or a valve cover gasket that is allowing oil into a cylinder. If it is the latter, one of the plugs you pull should have oil all over the bottom of it.It won't want to accelerate hard, or run good at high speeds. If there's any doubt, change the filter. They are cheap!
how do you replace the valve cover gaskets on a 1989 toyota, 4wd v-6?
1: no good acceleration2: the engine shaking when put in parking
3.ur steering shaking when drive about 60-80 after 80 mph is stop
4: ur engine is going down
5:not enought gas come throught engine bay is block by nasty stuff
6:car cant rev up high
P.S USe 89 or 91
If it is the fuel filter, your engine is starved for gas so you can expect stalling, hard starting, sputtering and those sort of symptoms. If in doubt, change the filter. They are cheap and it never hurts to have a fresh one in there.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.