Question:
Answers:
locating freeze plugs on a 1993 Buick Le'Sabre?
I used a big hammer, a long screwdriver, some lubricant spray and some heat on my F250 a few years ago. It wasn't a 4x4 though.does my truck have air injection? how do i know?
Be careful when you pry... Just be firm, patient and let the lube soak in real good. Mine I yanked them out after letting them soak and resoak a few times over a couple days. Basically because I had another vehicle to drive... And because these things were on the truck when I bought it and it was never maintenanced by the previous owner for 12 years.
Did this cause any damage to my engine?
remove wheel,remove locking hub,remove snap ring on end of axle,remove outer lock nut(special tool)lock plate and inner bearing nut,remove caliper and slide off rotor and hub assaemblynote the inner nut has a small pin on it that locks into the lock plate,make sure that nut goes back on first with the pin facing out or the bearing can come undone later
get a manual to get pictures
Here is a website with pictures to show you how to do it.http://autozone.com/servlet/uibroker?for...
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.