My 1997 nissan sentra thermostat bolts wont tighten enough to hold a seal, how do i fix it?

Question:


Answers:

I took my 99 ford taurus as i was talking about it earlier.The car died on me the lights got very dim the?

do the bolts not get tight or do the bolts get tight but still not seal?
if the bolts just spin you need new bolts or heli coil the intake, if bolts get tight and still leaks make sure seal is good and you have thermostat in the right way and surface that the seal touches is clean.

where can i find a diagram of a CAV rotodiesel fuel pump?

If you running out of threads on the bolt then put some lock washers on it

What are the signs of a bad catylictic converter?

Hacksaw

93 Ford Mustang Transmission Problems?

You install it wrong and spoil the thread.use heli coil.
auto zone auto part.

I travel often and leave my car sitting for weeks at a time. How often should I change my oil?

Assuming that the bolts are not stripped then you need a new seal. Sometimes overtightening a seal will actually cause it to leak. I have also used that Silicon RTV that you can buy in an auto parts store to seal the joint.
More Questions & Answers ...

  • paint code (exterior and interior) for 2007 RAV4?
  • which car is better audiA698-99 diesel or peugeot607,2000-2002 HDi or volvoS80 diesel-99-2000?
  • Toyota 4Runner Rear Windshield Wiper Not Working?
  • About how much will it cost for new front & rear brakes on my 2005 Honda accord?
  • how long does it take to change a transmission in a 1994 olds cutlass supreme ?
  • Jeep Wrangler 06 Jerking steering wheel?
  • What is the correct tyre pressure for 17'' alloys?
  • Help. I'm Ready to blow a Gasket?
  • New exhaust system?
  • Problems with PASSLOCK II on 2003 Impala?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.