Why my starter housing break after i?

Question:
start my motor up?I have a rebuild chevy 350 motor .

Answers:

Any harm done to engine, etc?

did you shim the starter right or did you over tighten the starter bolt's. It may have cracked from being over tighted and when the motor flex to start it broke it then

---

What are the bits that you attach to a wheel nut remover/spanner called?

The starter housing broke? Did you shim it right?

---

Is it usual for a 3m dust remover spray can to be cold?

Some starters have to have shims between the starter and the bell housing. If you do not put the shims in it will cause the starter housing to break.

---

More Questions & Answers ...

Can u put WD-40 on spinners "20"?

What is a oil gasket pan leak?

How can I tell if I have a bad motor? What should I look for?

Stripped distributor cap hold down screws?

Please, please, can someone tell me where the flasher is located on a 1989 mitsubishi mirage?

What could possibly be wrong with my mothers car??

I will give 10 points to the person who answers this...?

How to get rid of scratch on car! went through the clear coat?

Cost to Repair Odometer and Speedometer for 1992 Isuzu Rodeo??

I have r134a refrigerent, and, my pipe used to be on like danger, but, I made it back to normal, what now?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.