Question:
1968 pontiac lemans and i have the disk brake kit from drums to disks front only.how much in labor and how much time should it take
Answers:
Wish to "Sandblast" Steam Locomotive 6167, What other material can be used, rather then sand?
Anybody that owns an old car has a duty to work on his car himself. Are you going to pay some bozo that only knows how to work on 90's and up cars?
I need to know how to discharge my a/c system to do work on it.?
Just follow the directions and do it.
How do I tell which of my half-shafts failed?
The time it actually takes is irrelevant, they will go by the labor hour book. It should not take more than two actuall hours barring no problems, rust stripped nuts etc. I am surprised you found a garage that will do it with parts you supplied, they make at least 30% on parts. Id say you should be looking between 250. and 350. dollars98 Dodge Neon AC Recharge question...?
6 hours for front, 8 hours for rear. With labor costs $75-$125/ hour, you might try it yourself.Whats best to take tar off of paint on cars?
awesome car! i have a '68 firebird that had drums. i ordered a willwood disc brake kit and changed it out myself. it took me about 2-3 hours to do the right job that included calipers and right down to the spindle nuts. labor wise it depends on who you take it to and what they charge per hour and just calculate that by 3 hours worst case scenario. good luck.What could cause Cylinder #4 to miss on 1991 Tercel?
If your "kit" contains new hubs, rotors, bearings, spindles, backing/dust plates, calipers, brackets and new hoses, then you have pretty much what you need.I just changed the front left rotor on 94 ford explorer and ABS light stays on?
I'm sure you can find a shop that will do it for you, it will take two to four hours to change over, at whatever "rate" the shop charges. That is between you and them.
IS 20W50 a good oil type to use in a 2000 toyota corolla?
This task shouldn't be too hard.be methodical in your work...be well organized and most of all, lay the parts out as they would be if built onto the car..this is a mockup build...Now tear one side down and replace it with your upgrade...
be sure your hydraulic lines are secured and tight.
My car won't start, but my lights, radio, heat, etc is fine (except they're a little dim)?
Tighten everything ti the recommended torque specs.
then finish the other side...
Where is the plug to check transmission fluid on olds alero?
Replace your master cyl and bleed the whole system, Twice to remove air bubbles that may be trapped.
1992 Chevy Blazer S10 problems- stalls doesnt want to stay started?
If going to power brakes, be sure to swap your brake pedal out as the leverage will be different as well.
HOW MUCH WILL IT COST to INSTALL A FUSE INTO MY CAR ?
Never re-use an old component, go with new...your life could depend on it.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.