Hey i have a 96 blazer and like they are known for my tranny went out iver never done a 4x4 tranny..STEPS TIPS

Question:


Answers:

What is the ignition timing setting for a 1972 jeep cj5 304 v8?

Lot harder and a lot heavier than a 2WD vehicle. There is a transfer case that needs to be removed as well. Buy the repair manual for the exact steps. Do not recomend using a salvage yard trans unless you have no plans on keeping the truck. If you are, then buy a reman from Jasper, around $2500 and up. You can try auto zone, they seem to carry transmissions now too with a decent warrantee.

Should I put a new aftermarket cold air intake in my 1998 Mercedes ML320?


good luck...

I have a 1996 Jeep Grand Cherokee Laredo 4x4?

Oh boy!!

2007 Toyota Camry question?


That's a MAJOR job.
Without the right tools, jacks, stands, and such you're not going to be able to do it.
More Questions & Answers ...

  • Where can I go online to see diagrams/pictures of my ford truck engine?
  • My 2000 ford ranger starts vibrating at 60 miles per hour or higher, but it quits when I let off the pedal?
  • How to install front coil springs for 1964 Chevy Impala?
  • Buick regal t-type?
  • Do you need a turbo in order to install a cold air intake?
  • Clicking noise while accelerating?
  • When to use the "over Drive" feature.?
  • How do you set the timming on a 1990 chevy tbi engine?
  • Where can I find Ford Explr engine bolt torq spex, and sequences, head, manifolds, etc??
  • Engine cranks slowly once or twice before starting?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.