How do I tell without pulling the heads, I am referring to a 1995 Dodge Avenger, 2.5 ltr 24 valve motor
Answers:
How much for an O2 sensor for Elantra wagon?
The bad news is that someone has correctly identified this as an interference engine (the 2.5 4 cyl isn't, but the 2.5 V6 cyl is), so you'll have bent much more than your pride when your car stranded you.ABS light coming on ,car wont start?
Suggestions above re: checking compression after replacing the belt are OK for checking the valves, but I don't give you very good odds for liking what you see. Further, it might not point out piston damage that only running the engine or a physical inspection would uncover. I'd be considering when and how I was going to pull the heads and have a look.
How old do you gotta be to get a car put in your name?
If it is an interference motor, and the belt broke. 99% chance you bent or broke something. Did you replace the belt yet. If so you can do a compression test on each cylinder.How do i get a stripped bolt off?
Not necessarily - it depends upon engine design.1982 int dt 466 engine, where dose the oil temp sending unit go.?
I've no experience of this engine; however the way to find out is replace the belt, set the valve timing and do a compression test on the cylinders.
How do I get my front end lower on my honda?
yep,they're bent.What would cause an auto to not accelerate?
if u have 4 valve per cylinder then most likely valve are bend cuz it is much smaller than 2 valve per cylinder.How to install a ignition coil pack on a 03 cavalier?
You can always do a compression check to see if your valve are bend. Take all spark plugs out and insert compression tester (get a cheap one) then crank engine over at least 5 times.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2009 CarQnA.com All Rights Reserved.