Question:
Im installing a new horn in my 94 pontiac sunbird and i was woundering how to tap into my old horn? any website help? should i send it to a mechanic(im under a budget)
Answers:
Is the crank pulley supposed to turn? its froze .Dont know how to take it off?
Find the old horn and splice into the wire and have both work at the same time , or unplug the old horn and have the new one work only.If you are just adding a horn find old horn on vehicle and tap into the wires going to it.
Do fuel saver gizmos that you put on your gas line really work. They claim to add 10- 20% more mpg?
There should only be two wires, hook them up to Ur existinghorn wires and give it a try or a (toot). If still no horn, check
5 amp fuse in accessory or horn slot, probably blown, replace it
if needed then is should work for sure.
Is there anyone or any business that will rent a engine hoist in the louisburg area?
Generally speaking, you should be able to remove the old horn, install the new one( maybe have to drill a hole ) and connect the same connector. Are you sure that the horn is the problem ? It could be the horn relay or the horn switch. Or for that matter you would want to check the fuse in case it got shorted out. I understand budgets, but you might want to consult a mechanic.What is the best way to remove the chrome trim from the windshields of my 63 Bel Air?
94 pontiac has ONE wire going to the horn, that wire is a "hot" or Positive wire, the ground comes off of the chassis. most aftermarket horns accomidate this type of connection by having a single terminal, if however you decide your gonna mount the horn away from the factory mounting point such as on a plastic body part, you will also need to run a second Ground wire from the frame of the car to the frame of the horn. as stated before, test operation if it works good! if not check the fuse!More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.