What happens internally when we change the gare,How can it use to increase the speed of ;bike?

Question:
Accelator is used to increase the speed of a bike by providing more fuel and air.Then what is the purpose of gares in bike.What is the difference bitween different gares.

Answers:

torque on a bull gear for a detroit engine?

Gears are used to compensate the difference between engine speed and drive wheel(s). As kinetic energy builds in the vehicle, gears will allow an increase in speed without "over revving" the engine. Have you ever noticed that the bike will not move from a stand still in top gear. The difference in motion between the engine and rear wheel is too much. Gears change this to increase torque to get you moving.

---

tail light problem toyota truck?

the gears change the final drive ratio.( how many revolutions of the crankshaft in relation to the rear gear on the rear tire. when you shift gears you change that ratio. it alows you to go faster, and to have more power throughout your speed.

---

have a 2002 sobering. It used to work really good but since last night it stopped working( because of weather?

gears are defined as the change of speed. for example if the bike is in the 1st gear. then the acceleration will be at maximum as u go on increase the gears the acceleration minimises. corresponding to the time. acelration are the rate change of velocity. gears are needed

---

My ford truck has high RPM when I put the pedal down.?

when u start an engine, it has a certain amount of rpm, pressing the clutch or putting the gear in neutral will avoid the power from being transferred to the wheel(s). The gears are nothing more than metal discs with teeth on them. These gears are of different sizes which helps in multiplying the power from the engine. that's all there is to it. 1st gear is the lightest and the biggest, final gear is the smallest.

---

Any troubles with Jeep Cherokees?

Gears are used to provide the torque necessary to move the bike .
The first gear has the most power and torque but least speed as it has to make the bike to move from rest.Similarily the power and torque decreases and the speed increases as we go down the order.Therefore fourth will have the max speed but least power which can be observed by trying to take the bike up a slope and if it is in fourth it will not go up or will go up with difficulty

---

More Questions & Answers ...

inlet manifold?

2006 Chrysler Pacifica electrical problems ?

I have a 2000 Plymouth Voyager that I'm starting to have problems with?? HELP!! HELP!!?

I have a 1999 Toyota Camery Solara. Starting it is erratic.?

What kind of education should I get to pursue being a mechanic?

how can I open a rover 75 bonnet when inside catch is jammed?

no cigarette lighter in my van, need to use my tom tom to keep it charged for long journey, can i get a?

what makes my window bind up?

what transmission will work in 96 ford taurus with a 3.0 engine?

veers right and shakes?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.