Engine running high?

Question:
Hello, I just have a quick question, I am not sure if my car is idling to high. When it is idling the meter reads a little under 1000 RPM like maybe 800 or so. Is this to high and what may I need to fix if it is to high on a '85 Fiero. Also another question not concerning the Idling, when I do ride and hit a bump I hear a knocking sound coming from the front left wheel, what could this be? I'm sure its a suspension problem or something of the such. Another thing is sometimes when I drive I will hear a quick "ding" out of no where like my door is ajar or something. Thanks, sorry for so much to read!

Answers:

For Those Of You Who THINK Mechanics Charge Too Much Money For Their Services?

800 RPM sounds reasonable , Some tach's are not too accurate . The knocking sound from the front could be be any part of the suspenion or even a loose blockheater cord. Have someone bounce up and down on the fender and see if you can trace it. I have no idea about the 'ding"

What happens if I put petrol in my diesel tank?

Your car is idling correct, a manual trans will idle the same, as for the noise get under there and look around check for loose bolts or nuts its not to hard , good luck

Mazda B4000 anti theft system wont allow it to start?

hakuna matata

Will a rear end out of a 72 ford f250 fit in a 71 ford f100 without fitting problems?

The RPM maybe listed under the hood.
Is it Automatic or stick.
The noise you here is common unless its a metal on metal noise.
But i m guessing its the rubber bushings that are worn out and need replacing.
Is it 4 cyl?
Many variables with your idle limits. Fuel injection / Carb.
But it should be under a 1000 about 800 i think
More Questions & Answers ...

  • Engine Help?
  • When i step on my brakes they kick back or something drops?
  • How to install mirror assembly in accord 2000?
  • What does it mean when the ABS light is on in a 1994 explorer?
  • How do you know when a brake rotor is bad? How do you know when they need to be turned?
  • How to check the High Tension Wire whether working or not?
  • Is there a web site i can go to that will tell me estimates for getting work done on my jeep?
  • How much would a head gasket cost to replace at a garage?
  • Olds Alero wheel problem?
  • Fender Flares for Cobalt?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.