Question:
Answers:
how do i change a freeze plug on a 96 s-10 blazer?
Bore.... is the cut in a block for the piston. Call the cylinder.Bore also tells you the size of the piston in the hole.
Is measured across the hole. You can change the Bore by cutting cylinder open more. Boring out. or sleaving.
How much oil in 10 litres of fuel at 32:1?
Stroke is the travel of the rod, that is connected from the crank shaft to the piston. You measure the stroke with the piston at top dead center as it goes down inside the cylinder til it stops and returns up. You can change the stroke using crank, rod or piston.
Good Question
What the heck is wrong with my car!?
The bore refers to piston size. The stroke is how far the piston moves. Increasing either or both increases power produced.Which direction the crankshaft center bolt shall be turn to loose?
bore is the diamater of the cyl.stroke is how far the piston moves up and down
Bore refers to the diameter of the cylinder that the piston travels in.
Stroke refers to the length of the travel of the piston in that cylinder.
how much would it cost to fix a blown head gasket on a rover 216?
Happy motoring
99 civic si timing belt diagram?
bore is the diameter of the cylinder , stroke is the length of piston travelwhere can i buy a replacement mirror- just the glass part- for a 1993 ford ranger?
the best way i know to put it is the bore is the size of the hole the piston fits ,or rides in,and the stroke is how long it takes it to get there,,,good luck,i hope this help,s.adding anti-freeze to my 1999 Mustang Cobra SVT...anything special I need to know/do/use?
Almost all internal combustion engines have a piston that travels up and down inside a cylinder. Like a tennis ball inside a tennis ball can. The bore and stroke refer to the size of the cylinder. The bore is the diameter and the stroke is the distance the piston travels down the cylinder.a leak in catalytic converter near the gasket cause me to not pass the emmsions test?
People who really know engines can use these figures to help understandhow the engine will perform. For the average person engine geometry (V-8, straight 6), displacement (2.5 Liters, 300 Cubic inches), horsepower, and torque are all the details we need to know about our engine.
I have problem during backing up of my 2002 infinity G20.?
when you either have to rebuild your engine from wear, or just want to increase your horsepower, you can bore the cylinders, or cut cyl. walls, increasing width from 10-40over..but boring the cylinders and increasing piston size does not increase the stroke, you get that from changing your crank & camMore Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.