Question:
It's an older ford and it's harder for me to work with, and no one around here seems to know how. Help would be greatly appreciated! =]
Answers:
Car Fuse Question?
Pull the grease cup off the end after you take of the wheel. There will be a cotter pin, remove it then the nut under neath it, then the king pin will be exposed, you probably just need to replace that bearing. If not go behind the disc and take the tie rods off and everything will become clearer. Good luck. I would also suggest going to Yahoo groups and join an F-150 group and ask for more help there.
Which situation is more dangerous in case of braking ...front wheels locked or car with locked rear wheels?
your best bet is get a chilton for that year [ have one ] send mail to heaychevy@yahoo.ca [ need time to look up ]
My front nearside wing is loose, will my car pass the MOT?
there is only one way.
1. drain the gear oil in differential
2 drop front driveshaft
3 Dis assemble the hub components
4 remove tie rod end
5 spilt the rear end
6 remove circlip that holds axle in differential
7 slides right out
8 reverse order to put back together
What is best to flush your trucks cooling system with if it is realy rusty other than store bought flush?
the name of that is spindle.
Car auto alarm installation help?
clear the spindle by removing the wheel and bearing and every thing.
You gonna see, the go through bolt ,holding the axle terminal( and king pin) with an eccentrically cone,loose the upper bolt and the lower bolt ,remove them completely.(mark the cones position for installation and alignment purposes)
hammer the spindle out (4 pounds hammer) in the same manner as removing the tie rod,it gonna fall.
More Questions & Answers ...Is it necessary to change automatic gear transmission oil.?
What kind of fuel should I use on my brand new Honda Accord Coupe 4 cyl?
auto coolant problems?
How long would it take to put on a head gasket? for a 2000 ford ranger.?
chevrolet motor 4.3v6 1992 keeps back fireing through the vortec.puter is fine and chip new tune up done HELP?
My car won't move out of "park" '95 Merc Sable?
What needs to be replaced on my car so that it will stop squealing when i accelerate?
Do new rear coil springs (2001 Taurus) need to be "broken in"?
My 2002 Impala LS (sport package) has warped rotors. How bad is this problem?
How much would 4 roter's cost me for a Ford Mustang?
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.