Question:
I have a 1991 ford probe and i think it has a fluid leak where do i check the fluid level and what fluid do i use to refill it
Answers:
Isuzu Rodeo..why wont blinker work but flashers will?
Look where the clutch pedal rod exits through the firewall. In the engine bay at this point you'll find an aluminium casting usually with a container on top where you put the fluid. This will be next to the brake master cylinder and brake booster. The fluid can be leaking from this clutch master cylinder, or the slave cylinder attached to the clutch throwout under the car. Best get it repaired.Buy bare wheels for $424 or same wheels mounted on new tires for $800?
There is two Master cylinders one for brakes and one for clutch both take the same fluid.How much would it cost to replace the hood on this Honda Accord?
There is a master cylinder right next to the brake master cylinder and also a slave cylinder down near the bell housing. Most clutches use brake fluid but check your owners manual to be absolutely sure!not all stick shifts have a hydraulic clutch, if you do it will be beside the brake master cylinder and it takes brake fluid.
I need to find the trunk drain hole in my 1994 Nissan Altima?
Your clutch fluid reservoir on the 1991 ford probe is right on top of the engine it should have a yellow cap on it. situated at the back. DO NOT OPEN IF YOU HAVE BEEN RUNNING THE ENGINE EXTREME PRESSURE!! Check your vehicle manual for the required clutch fluid but if i remember rightly it should be bog standard.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.