Help! Anyone know the location of spout connector on a 1997 Mazda 626 for timing??

Question:
We need it to time the darn car. We've looked on the net, we've asked friends at diff shops in town. Auto zone shows us a pic, but yeah, it is not where they say it is!! I know that it is grey and has a shorting bar hooked into it, but where is it?! Going nuts! Please help!!

Answers:

Car overheated - water leaking from somewhere?

There is no spout connector. You have to ground the DLC points. Here are the ALLDATA instructions"

1989 Toyota Celica ST won't start?

IGNITION TIMING

Battery very low, won't start with the key...?

Verify that the idle speed is within the specification.
Specification: 600 - 700 (650 ±50) rpm

My car won't go faster than 25 mph when the engine is cold, Why?

If not as specified, adjust the idle speed before proceding. See: Idle Speed
DLC-1 Timing Jumper Location

will 2005 intrepid r/t rotors fit a 97 intrepid?

Car uses too much gas?

Connect the Data Link Connector (DLC1) terminals TEN and GND by using a jumper wire. NOTE: The IGN- terminal can be used to check idle speed.
Verify that the idle speed is within the specification.
Specification: 550 - 750 rpm

1996 old cutlass cierra 4t60-e?

If not as specified, adjust the idle speed.
Connect a timing light to the high-tension lead of No.1 cylinder.
Timing Marks

would low break fluid cause the check engine light to come on ?

Problems with power steering??

Verify that the timing mark (yellow) is within the specification.
Specification: BTDC 9 - 11°(10 ±1°)

Do I have to use same manufacture's tire to replace the flat one ?

Timing Adjustment

Where is fuse #31 located in a 1995 nissan altima?

Homemade Battery Additive?

If not as specified, loosen the distributor lock bolts and turn the distributor to make the adjustment.
Tighten the distributor lock bolts to the specified torque.
Tightening torque: 19 - 25 Nm (14 - 18 ft.lbs.)

Pennsylvania Residents?

Disconnect the jumper wire.
Verify that the ignition timing is within the specification.
Specification: BTDC 6 - 18°

---

Is there a key lock for the tires on the Ford Sport Suv?

look up under the glove box area on passenger side of car.

---

More Questions & Answers ...

I need to know exactly how to harden A2 steel.?

car interior?

Rolling road?

Ford OBD Code1260?

how many times can you paint a car?

Im not comfortable with the gear system in my Honda Shine bk which got recently how do u get it smooth?

When I brake and let go...I hear some weird noise. What could be wrong?

1999 Toyota Camry's engine shaking?

I want to change the bumber of a Minicooper how much will it cost for me?

Should I have the idler arm and ball joints replaced on my 2000 F-150.?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.