Can you help me on a 1992 sohc dodge stealth?

Question:
I have a 1992 dodge stealth sohc--I do not have any spark from coil--I replaced ICM--and the coil checked ok with ohm meter--I am from the old school mechanic 60s and 70s--but this new stuff ecm and sensors has me lost --I don't want to take it to a garage---I know how they work --I have worked in garages--but I was honest--please help me if you can--thank you

Answers:

Does anyone know where i can get a owners Manuel for 2005 for Taurus?

Don't let my intro fool. you. I worked for dodge for 10 yrs. I had a problem like this. it drove me up the wall for a couple hours. I even changed the crank sensor.Finally I broke down and started looking for tsb's. I found one that involved performing A harnesss wiggle test. Reconnect everything. Grab harnes between relay box and dist. There may be a hold down u may want to remove. So you can really move the harness around. Have someone crank the engine. see if it starts. The problem with this design. Is that when the engine and trany move. They where pulling on the harness. Breaking the wires internally. So the wires loOK ok from the out side but are broken on the inside. U should get a schematic from your public library. To help u Id the correct wires to check for continuity. Also check your mounts when done
Hope this helps..

---

I need directions for mounting a rear air-deflecter for a 04' Jeep Liberty.?

Could be a bad key . The keys are coaded and if the chip goes bad the car won't start .

---

how do i rplace the lifters on my 1984 pontiac fiero 2m4?

I am currently having the same problem with my 1997 dodge neon 2.0 SOHC. I am not getting any codes and I have narrowed it done to the PCM (powertrain control module) I have spent hours working on that car and replaced many things and like I said I have traced the problem back to that. I am getting a new one here in a few days... Try taking your current pcm to someone who can bench test it. Hope this helps!! And to the above answer, the keys in 1992 are NOT coded. Chrysler did not start this untill 2001.

---

need i mass air sensor in order for a cold air intake system to work?

crank sensor the way i am taking it

---

How to figure CFM?

This problem could be a broken wire comeing from the cam position senser.The computer has to recieve a signal be for you get spark.

---

More Questions & Answers ...

My ford E350 burns a lot of oil and smokes a bluesh smoke when going uphill?

honda civic?

What is your experience with Maaco?

I need to find some replacement door panels.?

installingwaterpumpon97oldsmobile 88?

Am I being overcharged for brake work?

What is the best overall cam for a 383 stroker?

How to change out a heater core in a 1996 Mustang Coupe?

I keep trying to stick this fork into my electric outlet to clean the lint out and I can't make it fit. Help?

how much will an alternator cost for my 88 honda accord?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.