Brake caliper?

Question:
loose caliper new pads and rotors bled system new slide pins and bushing and new caliper wont tighten even with bleeding driver side tight but passger side still loose and vibrates when applied brakes abs brakes 1995 buick regal

Answers:

What would you do??

The piston is stuck. Remove the caliper and use a C Clamp to push it back in carefully. Reinstall and try again. If it doesn't work, you will have no choice but to rebuild or replace the caliper. Would think the replace is better for you.
Brake Caliper Rebuild see first source below.

My dead car battery leaked fluid into the trunk of my car. Now it smells horrible. How do I clean it?

On occasion, we can get them to come loose by taking loose the bleeder screw and prying on the piston with a big bar. They will break though.

2000 Chevy Impala?

You may need to get new calipers up front, if so, bleed the system well after fluid renewal.

---

New transmission or just a minor repair?

when bleeding brakes on passenger side if your getting fluid from it then you have a faulty caliber but if you are not getting fluid then you have a blockage in the line or you need to bleed it more. hope this helps.

---

Where can I go to get my head light fixed? Will local auto repair places do it?

Sounds like something mechanically wrong not something with air in the brake system.

Remove Scratches from the Windshield?

Did you try manually compressing the brake cylinder with a C-clamp?

---

I work at a plant that uses sulfuric acid alot?

Thank you. It sounds like the right side(new caliper) is loose and the left side is grabbing. which is making your wheel speed sensor apply the ABS(pulsing).take the wheels off and see if the pads are touching the rotor. pump the brakes(engine may have to be started, SAFETY FIRST) until they touch, (you may not have gotten all the air out of the piston) Make sure all the parts are correct, you may have to take it apart and start over.

---

Intermittent knocking from right front tire area?

sounds like air, bleeding order,pass side first then drivers. general rule is the farthest point first.you might have to rotate the bleeder towards the top also good luck

---

More Questions & Answers ...

Is my fuel injector clogged up?

Wiring and firing info for 1994 Olds Cutlass Supreme V6 3.1?

How do I remove the fuel injectors from a 1993 Eagle Vision?

How much does an engine rebuild cost?

1993 gmc suburban, the oil filter adapter is leaking and i am wondering how difficult it will be to change?

How much are you paying for regular gas in your area? Where are you located?

ca i fit a universal air filter to my cinqucento sporting?

Where is the coolant temperature sensor located on a 4 cylinder 2000 Ford Contour.?

Does anyone know of any good Online Auto Repair Manuels?

Have fllooded car!?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.