What would be a ball park figure for a brake job on a mid 90s Chevy lumina?

Question:
I haven't noticed any problems. It is high mileage and probably is due basic service

Answers:

Where can i find the correct timing on a 4 cycle robin/subaru go-kart engine (10hp)?

It should run you between 200-350 bucks, assuming there is nothing else that they find that would delay the repair. Allocate a budget on how much you want to spend on the brake pads, rotors and calipers.

When is it time to retire?

Probably $200-$300... and dont be surprised if all you get is a set of $20 brake pads, all brake shops rape everyone they can, get the parts and do it yourself.

Is it ok to run cold air intake without MAS? Should i rather go with High Flow intake? Wil sound be differnt?

89.99 at madias ,23.99 if u doe it yourself

Dodge man out there?

I assume your going to have a garage do it, so can be up to $300. Depends on what they say you will need. Example would be rotors, brake pads of course, and the best of all for them, brake calipers. Then brake fluid to replace what they had to let out replacing them calipers. That might be just the fronts too. Maybe more for doing the backs.

88 bronco 5.0 4x4?

150 and up depends on what needs attention too but for a turn rotors and replace pads and adjust rear brakes 150 and up
use good brake pads dont use cheap crap you will regret it
when you drive around with squealing noise and weak stopping power
get bendix or factory oem parts

My check engine light came on (yellow). Where is a good dependable place to get it checked out.?

$90 to $300/axle, depending on what needs to be replaced. Pads only at the low end, rotors and calipers on the high end.
More Questions & Answers ...

  • I have not done it for awhile, but I need someone to tell me how to bleed my brakes on a 87 chevy nova, thanks
  • Anyone know a good mechanic??
  • How does the Bureau of Automotive Repair help customers with complaints against a repair shop?
  • 98 Dodge Neon AC Recharge question...?
  • Water boiling on a BMW 316.?
  • Coleman generators?
  • Cadillac engine install?
  • Oil Question Shell Rotella vs. Mobil 1?
  • Tire size question?
  • Auto Maintenance Needed - Dealer or other Mechanic?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.