1995 Toyota 4 Runner clutch help...?

Question:
I have a 1995 Toyota 4runner, 3.0 liter 6 cylinder 4 wheel drive truck. I bought an after market kit from Rhino that included the Disk, cover, pilot & throw out bearing. I pulled the system apart, had the flywheel resurfaced & then put it back together. Before I hooked up the rear drive line I testied it out... I started the car, put it in first, clutch in & shifted into reverse... Fine. I turned the truck off. Then I pushed the truck out of my shop & connected the drive line. The truck would then not shift into gear while it was running. I have bled the system, twice just to be sure. Still nothing. The pedal seems a little soft. Also if the truck is stopped & I put it into gear & push in the clutch I cannot move the truck.. it is as if the clucth is not engaging all of the way.
I don't want to have to pull the whole thing apart & if I do I don't know what would be the problem. I made sure everything was aligned and tightened down evenly to keep it that way... help

Answers:

will 33" tires fit on my 1989 bronco 2 without a body lift?

well you may have a bad slave cyclender or a bad mster cyclender and if so you need to replace it then rebleed it

on a pug 106, can u buy GTi arches and skirts and fit them on a normal front and rear bumper?

If the clutch is soft you have air in the system. Is the clutch master cylinder full ??

A question for auto mechanics/transmission fluid change?

often times you must replace all hydro parts when clutch is changed

More Questions & Answers ...

How can I take care of my car in such a way that it will last longer?

Piston knocking could it be the spark plugs?

Their are 2 baseboards wired to one thermostat. The heat will not shut off when the desired temp is reached.?

my uncle changed my oil and put atleast half a quart too much in my car will it damage it/how do i fix it?

FUEL INJECTOR AND CARBOURATOR Cleaner, is this good for your car?