Question:
how hard is it?
Answers:
I have a 1997 Pontiac Grand Am, what will make the it cut out?
its very rarely a pulley problem - it is more likely that there is no gas in the system sensors detect this and will not let it kick in get the system recharge and checked for leaks.Vauxhall omega running problems v6 2.5 m reg auto petrol?
Unless you have an air impact wrench, it's impossible.Hi,my 2.9 ford has 2 new heads and gasket but still it send combustion gaze into the cooling system?
It just keeps turning, and turning, and turning.
How do i drain a 2006 honda accords gas tank,accidently put desiel in it. please help?
Not if you think it's on the condenser. It's on the compressor and if you had the proper tools it's not that hard. Take the belt off, unbolt the thing unhook the wire. Then do the reverse.Problem with 2000 Grand Jeep Cherokee Limited?
Yes it is possible if you have the replacement parts but is a tricky job and so best carried out by a professional. It may be easier to change the whole compressor (I guess by condensor, you mean compressor as the condensor is the radiator part of the air conditioning system and the compressor is the pump.) Remember the system needs to be re-charged after the job has been completed.Is the Saturn Vue a mechanics nightmare? Tell me it ain't so!?
have system checked it could be as simple as blown fuse to no freon in system (leaked out) bad compressor , relay its easier to replace compressor as a assembly u have to set air gap on clutch when installing new one it can get complicated according to your mechanical skills good luck hope this helpsHow do i get the , H,T Leads off a v6 merc engine,?
you should first bypass the low pressure switch on the filter dryer...big aluminum can...if you short the two connections it will come on if not dead, or check the ground on the clutch, there should be power into the clutch and a grounded wire going out of it...check both with a lighting probe...looks like an ice pick ...hook the clip on the probe to the block and with the ac on max you should have one wire that lights the probe...next move the clip to the positive connection on the battery... test the wires and one should light the probe...you can change the clutch ,but it calls fo special tools and is best left to the pros...More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.