Question:
My driver's side window won't operate, but all the other windows are working fine. How can I fix this? Please help! The window is stuck down!
Answers:
what happens if there is crack on my range flat top that just broke off?
Most likely a bad window motor. You might try hitting on the door while holding the switch to get it up.1999 Honda Civic, how long does the battery usually last and how much are they to have installed?
take off the door panel and see if your wireing harness is attached and the wires are fine. If they are take the wiring harness off, pull out the thing that has the buttons and replace it. You can usually find them at the dealership where u got itMy rear lights aren't working but my headlights are. What is the most likely cause?
open the door panel and check all the wires going to the motor if they are then the motor is bad or it maybe the window switch get a new switch and replace itI own a 1992 190e mercedes mileage approx 180000km.?
Does it make any noise when you push the switch? If so, the motor is probably working, but maybe the window is off the track. There are a lot of plastic parts on some of the internal window mechanisms that can get brittle and break over time.If a starter,alt.,and battery are good,what will cause a car to click and not turn on?
You need to pull the door panel and see what's going on inside.
I am so fed up with these people telling others to go to a dealership to find a replacement part!
Please hold:
I just called my local pontiac dealer, and the part number is 12362503.. cost $156 and some change.
here is the EXACT SAME PART (1AWPM00001)
http://www.1aauto.com/1a/windowmotors/po...
$44.95 + $9.00 shipping.
Dont want to spend $55.00? ok
Online Junk yard cost: please hold: Junkyarddog.com
Rebuilt motor part number 12362503=$30
Ok, dont want to spend $30?
Local junkyard: Drivers side window motor for a 1990-1996 grand prix=$10
If you can change your oil, you can replace this yourself. It is a peice of cake.
DONT EVER BUY A PART FROM A DEALER. You could buy 10 used motors from your junkyard, and it would still cost less then buying a part from a dealer.
I can understand needing to buy a part for a bently gt froma dealer, for the fact that they are a low production car, and not everywhere, but when a car platform has a production number of over 500,000 parts are easy to come by.
turbo chargers/super chargers?
first check fuses, some autos have fuses for each window, if this does not work you , try removing the switch (usually pops in and out) from the trim panel and check connections, if this does not work you must remove the trim panel on the interior side of the door, this is not that difficult, there is usually 4 to 8 screws(some may be small bolts) that hold it on, some are hidden under the arm rest part, you may have to remove inside mirror cover also, some screws are located under the power switch for the window, after you believe you have got all the screws, grab the trim pad by a secure place and try to lift up firmly but not enough to break any plastic. Some pull out from the bottom first, some pull straight up to come off, make sure when you get it released to disconnect any wiring , no two plugs are the same in there so don't worry, and set aside. remove vapor barrier and all becomes visible.hope this helps
Bob
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.