HELP PLEASE: 2001 Dodge Neon with a STARTER Problem!!!?

Question:
My starter went out a month ago, so I went to auto zone and got and a new starter. The starter worked great for about five starts then a couple rough starts and then just "click". Took the car to a mechanic and they said I have a bad starter and I should get a new one. I took the starter to auto zone and they tested the starter which failed after a couple starts. I got a new starter and installed it. Same thing happen with a couple good starts and then just clicks and rough starts. Took the starter back to auto zone and got my money back and went to O'Riely's auto parts. Guess again, same thing. I inspected the fly wheel and I see no harsh signs of wear or broken teeth. I don’t want spend $500-$1000 to have a mechanic put in a new fly wheel. I don’t see how an average condition fly wheel (Has all its teeth) is busting my starters. I'm lost. Does anyone have any ideas besides getting a new fly wheel or shims (not need for Neons) for the starter? Is there a short and long nose starter?

Answers:

Should i put the cold air intake in my Honda civic 02 LX MT?

Not that this helps, but I couldn't resist.

Can a stuck thermostat on your car make it overheat?



Hi! Welcome to the Dodge Neon experience! You have selected the car of choice for young, broke, "on-the-go" people such as yourself. The Dodge Neon has all you need, whether it's the spacious glovebox to hold your Crumpler purse, the cosmetic mirrors on both sun visors for putting on your Lucky Chick makeup, or the extra thick rearview mirror, perfect for hanging a troll doll. Would you expect any less from a car named after what gave the "Red Light District" its name?"

How do you install a spark plug coil pack?



How do you adjust the headlights on a 1995 camry?


"Steps to operating the 4.5 watt AC Delco radio

I have a 1990 chevy 1/2t ext cab can you buy a replacement steel brake line that goes from mast. cyl. to back?


Step 1: Turn volume knob clockwise until you hear an audible click.

What are the hours of operation of Care Muffler and Brake in Danville, IL on saturday?


Step 2: Replace volume knob after it snaps off by pressing inwards and rotating counter-clockwise.

Is it worth it to do some body work on rust patches on the body of my jeep?


Step 3: Slide shifter to N.

How do i remove grazy glue from truck without messing up paint job?


Step 4: Push car off cliff.

Failed MOT due to cut in tyre?



1993 Camaro Z28 detonation problems?


"Steps to perform oil change

My check engine light came on (yellow). Where is a good dependable place to get it checked out.?


Step 1: Turn off car.

Can a 2002 Ford crown VIcoria run on ethanol??


Step 2: Slide shifter to N.

How do you set the timing on a Ford 4.0 SOHC?


Step 3: Raise hood.

I just in staled a cold air kits on my 95 olds acheva and now it keeps dieing when i stop can any one help me?


Step 4: Wait until white smoke clears.

How much will a new tire rim cost with work included? (the metal part inside- that the tire is on)?


Step 5: Unscrew oil cap on top of valve cover.

When is it time to retire?


Step 6: Push car off cliff."

I need tires and rims for 92 toyota camry?



1992 cavalier?


"Troubleshooting tips

Would it be really expensive to get an old car that runs, but needs to be restored?


Symptom: Grinding noise coming from wheel, gets louder with speed.

Why do my car's brakes go out when I'm making sharp left turns?


Solution: Remove hubcap. Drive for 5000 miles. If problems persists, push car off cliff."

My rear view mirror fell off... How do..?



My 1986 300ZX squeaks when it rolls backwards, regardless if it's in reverse or not.?


"Steps to perform motor mount refill

Will door poppers work with lambo doors?


Step 1: Support vehicle securely on jackstands.

Hello everyone, can sum1 pls tell me how to reset the timing belt light in a toyota regius 2000 model.thanx?


Step 2: Raise "engine" with jack and a block of wood underneath transmission.

How can I make a warning indicator for my car for when my headlights are on and my ignition is off?


Step 3: Remove center bolt of mount, remove mount from vehicle.

What is the difference between gelcoat and clear coat ?


Step 4: Refill mount with only genuine Knott's gelatin.

Car Security Alarm Instalation.?


Step 5: Re-install motor mount.

How can I remove the wiper blade off a Chevy Monte Carlo?


Step 6: Slide shifter to N.

Car battery question?


Step 7: Lower vehicle and push off cliff."

Where do you take your car to get a inside handle replaced?



What color is the Power steering fluid in the container..?


"Disposal Procedure should there be no nearby cliffs

What can be wrong with an 04 cavalier if there is a miss in the fourth cylinder?


Step 1: Drive vehicle to local boat ramp.

Some tips for performance on my 2 stroke engine please?


Step 2: Lower both windows.

Is there anyway to make a car seat cover homemade for Ford Escorts?


Step 3: Slide shifter to N.

Can I use 87 octane gas in my 1993 Lexus SC300 - manual says use 91 octane?


Step 4: Push car down ramp."

Nitrous for inline 4?

check and see how far the starter is going back to the flywheel.it might need shimmed or some shims taken out.
More Questions & Answers ...

  • I need help after chaging distrituter on my car?
  • Where is the best place to get 2 new tires and an alignment?
  • Where can I get a new Car seat?
  • How much oil does a suzuki marauder take?
  • How do you repair heater hose crown vic 1998?
  • What can I do to adjust the striker on my car door panel?
  • Saxo 1.4i-green gunk in radiator tank?
  • I'm converting my S-10 2wd blazer to a 350 engine.use to be a 4.3 TBI eng.?
  • Good/cheap place to get car painted?
  • I have a question about my car?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.