The seat wont go back in my mustang or camaro?

Question:
I just bought a 65 mustang and 67 camaro and for some reason the seat wont go back in either of them. It's acting as if one of the rails is stuck my camaro has a bench seat and there's one side the drivers side that's working fine and the paasenger side wont budge and with my mustang same type of situation only their bucket seats any recommendations on how to get the seats to go back?

Answers:

Place spark plug wires on a Chevrolet Suburban 1993 8 cylinder?

If it has been a while since anyone has tried to move the seat (years) then there may be a build up of gunk on the tracks that the seat slides on.

1993 ponitac sunbird where is fuel pump located?and how do i access it?


Use a socket set to free the tracks from the floor. Lay the seat back (freed from the floor) & both tracks apart on each seat. Use WD40, some rags, & some muscles to clean all the grease and dirt off the tracks.

Problem with VW Jetta?


Once they are clean I would re-grease the tracks, put them back together, & bold them back to the floor. If that doesn't work I think I would take it to an auto upholstery place & see if you could have them look at it.

Cost to Repair Odometer and Speedometer for 1992 Isuzu Rodeo??


It sucks that it is the same with both cars.

Factory 16 inch rims, aluminum, fit for 205 width tire. Wanna take a stab at how much it might weigh?


BTW I am jealous as hell of your "new" cars.

Can a car has some hydrolic jack at centre of base, around which it lift itself and rotates to turn .around.?

try spraying the tracks with wd-40.might have to dismantle and put some grease on the track..

What is the suitable oil for ISUZU TROOPER (Benz)?

CHECK UNDER THE SEAT THERE IS OFTEN A SPING WIRE THAT RUNS FROM ONE SIDE OF THE SEAT RELEASE TO THE OTHER. IT SOUNDS AS IF ONE SIDE IS DISCONNECTED.

I need a 1977 ford courier wiring harness diagram doaes anyone have one that they can share?

There is a metal rod/wire connecting the direct acting lever, and the other pawl on the other side, sometimes these come off, or stretch a bit. Look under there and you can watch the action when you pull the seat adjusting lever..."both" sides have to disengage the ratchet teeth on "both' rails...
More Questions & Answers ...

  • How do I get my trunk to open when I push the button?
  • Exaust Tips - Do I have to do any welding with an exaust tip that has a clamp-on inlet?
  • What is a diagnostic code scanner?
  • Will resurfacing rotors get rid of high speed vibration when braking or do i just need to get them replaced?
  • How do you fix a scratch on a car panel with clearcoat and blend it so that it blends w/the rest of the panel?
  • My 95m toyota corrola doesnt seem to warm up.?
  • Where can I buy purple window tint?
  • Why does my truck have a rough idle?
  • DIY Car Repair Possible?
  • Corolla 1990 transmission fluid?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.