Question:
Answers:
That's so trashy and ghetto hopefully you don't figure out how to put it!
Any tips on removing/replacing a water pump on a 1988 Cadillac Deville with a 4.1 front wheel drive?
go to best buy and they could do it for uhow much to spray your car a different colour?
Buy a kit, Its got the instructions and equipment needed inside.Does car towing do any damage ?
Why would you want to? You will hate it in about a year!anyone had a cam belt snap on a 1.2 p reg clio and it not bend valves?
You can buy car kits at Autozone, Pep Boys, etc that will show you how to do it...
auto eletrical mobil near aberbargoeod south wales?
Hire somone or tape it with duck tape.A friend of mine has window paint on her car windows...?
Usually with screws and brackets.they sell kits.
Do tires get flat spots in cold weather?
or just steal a sign from your local pub if you are old enough to get in, and duct tape it to your muffler using the cigarette lighter as the power source.
The kit should have a wiring diagram.
Pull a wire from the proper place in the fuse box or battery line with an in line fuse and attach it to the proper place in the light that you have screwed to the underside of the chasis by first drilling the proper sized pilot hole for the metal screws included in the kit.
Then bring the ground wire to the lights and attatch to teh proper place.
Macco advertises a $200 paint job, but........?
Somewhere along the line make sure the wires rout through an area close to the driver's controls so that you can install a switch. or rig it to the headlights so they will activate the Neon, your choice.
If you can follow instructions you should be able to accomplish the task.
What does it generally cost to replace a bad oxygen sensor?
Good Luck!
found an auto repair policy for mechanical repairs only. cost 300 a year. good deal?
you can buy kits at probably most auto parts stores.you may want to check to see if they are illegal. some states they are. i beleive in my state (CT) it is OK to have them installed but not turned on while driving, you can only have them on while parked, and i believe with the engine off.
before installing them permanently place them on the frame with tape and power them up to see how much light you can see, or can't see, once you have the postion set check out the way you will run the wires, make sure they won't get pinched, or entangled in the emergency brake cable etc. once this is done start the permanent installation.
Hope this helps, good luck
alittle advise theres a thing on the box ''the box that the neons came in'' called directions or instructions read them (duh)
don't do it. they look gay.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.