I was driving my 97 ford ka on the motorway earlier i was doing around 80mph and then it suddenly lost power?

Question:
it then decided to not go any faster than 40mph and kept pulling back, the power would go then come back? does anyone no what could be causing this? also the k&n on it sounds really loud now because of it? it still drives but it srugles to go any faster than 30mph?

Answers:

How much does a carwash cost?

Is this the HCS push rod engine or the zetec 16 valve?! (engine cc would identify it) the HCS Eng is an old very reliable engine with hardened seats designed to run on unleaded fuel, the zetec is a performance multi valve engine, fords modified the Hyd Tappets 3 times between 1994 & 1997 to resolve burnt out valves then reverted to buckets and shims (manual ajustment) to resolve this problem.
both are quite good engines, howeaver the description you supply points to either the ECU throwing a tantrum or possiabley burnt out exhaust valves, or incorrect seating.
check valve clearances (where possiable) Compression test, cylider leakage test, to identify problem, i have known fords to have valves sieze in guides where they ars not totally compatable with unleaded fuel. I:e every third tank of petrol needs to be leaded to avoid siezure.
If the ECU has shut down into get you home mode it will have excessive fuel consumption and will only return about 25 to 30 MPH ECU will need resetting by someone with equipment (not Necessarily Main Agent)

Looking for a car shop in sfo that is expert with old toyota's 1970-1980 models?

Assume you were in the UK - why were you doing 80mph?

98 durango 22" rims?


If you experiencing this type of problem with the power, I would suggest taking it to a garage.

How often should you change the oil in your car?

Its your punishment for doing 80mph when you should have only been doing 70mph.Clever car you have there.

A car question..?

the worst that could have happened is that you blew a seal...if your headgasket went out it can be an expensive repair.

Car overheating after driving a long distance?

I didn't realise a Ford ka went faster than 60mph, even with a following wind!
No, seriously, it sounds like the engine is firing on fewer cylinders, or the timing has gone completely AWOL!

Should I change tires on my car?

Certainly sounds like your cylinder head gasket has gone .. continuing to drive it before it gets repaired could do some serious damage to the engine . you're probably looking at a few hundred quid to get it fixed depending on how bad it is.

Exaust Tips - Do I have to do any welding with an exaust tip that has a clamp-on inlet?

You could have blown 4th and 5th gear.

My motorcycle (a Suzuki GN 250 1993) is backfiring.. why?

Bet you were going down a hill!

R Reg ford escort Encore 16v DOHC Auto?

Most Ford Ka's struggle to do more than 30 mph. I think the technical term for your problem is -its knackered..

Master Engine Rebuild Kit?

I've had two cars do this but for different reasons! The first was an old-school Mini that needed a new distributor cap (the nice AA man sorted that out for me). The second was an Astra and the starter motor had gone so I ahd to pay £150 for a new one. If you can still start your car, it's obviously not the starter motor that's the problem!

2002 Ford Focus - Electrical - PCM Board replaced. Other Electrical items haywire - Help!!?

Mine did that and it was the spark plugs, the garage either hadn't changed them during my service or had fitted the wrong ones, it got gradually worse, at first it only did it occasionally on the motorway but eventually it wouldn't even do 30, if you've had it serviced at a garage they should fix it for you if it was their mistake as it was in my case. You can get spark plugs for about £15 in halfords but they're ridiculousy hard to change in a Ford.

On engaging 3rd gear grinding noise occurs?

If it sounds louder, it could be an air leak.
have you sprayed the K&N with filter oil recently? The oil is renowned for causing problems for the airflow sensor if you over oil the filter.. Is there a yellow light on the dash with an image of an engine?

What happens when you drive with your parking brake on?

lol its a KA not a ferrari ur lucky to get anywhere nr 80 u have sooded it now lol

How hard is an exhaust system to install onto an suv?

You've wound the rubber band to tightly and it broke?

Front brake problem/ Cant seem to bleed. Working on front end and had master upside down for a few days. Help?

Possibly an ECU fault. On some cars, when the electronics detect a fault, it goes in to "limp home" mode with restricted power, but without more info it could be many things.

Looking for location of Aspire oil pressure relief valve assembly.?


I'd question the decision of using a K&N filter; the difference on a Ka would be negligible. Check the filter, it could be clogged with muck.

Is there anyone out there that has a car that is a saturn?

Sounds like the computer is in emergency get you home mode. Just give it to Ford and let them sort it out. As it is 10 years old they will probably bin it anyway.
More Questions & Answers ...

  • Where is the Oil Pressure Switch for a 2001 grand am located?
  • Why do my power windows sometimes work and sometimes not?
  • 1993 240sx its been sitting over a year will not start.?
  • Rain and new squealing sound?
  • How do i check my manual transmission oil?
  • Why would my ABS light come on after a complete new brake job on my 1993 Mercedes Sel 400?
  • Oil leak!! please help?
  • How do I get my front end lower on my honda?
  • How do I remove rear door panel from 98 Oldsmobile Intrigue?
  • What kind of tape is safe for car paints.?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.