Tyres should i change em.?

Question:
Bought a Porsche 911 sse. it has bf goodridge tyres on. Are they a decent tyre or will i or will i carry on straight ahead at the corner??

Answers:

My saturn sometimes dies when I put it in reverse! Whats seems to be the problem?

Goodridge are reasonable tyres, check the ratings on them to ensure that they comply with manufactuers recomendations.

I have an 04 plate Corsa & it makes a creaking/groaning noise when people get in & out of it?

Most of their models are good, yes. They are different though, and you don't list the tire model/size.

What Battery do I need for my 1980 Bedford CF250 Motorhome and where is the best place to buy one?

Yes BF Goodridge Tyres Are Ok, But Check How Old They Are, Check For Crackes In Side Walls, If In Any Doubt Pop Into Any Tyre Garage And Ask Them, If Its A Good Garage They Should Be There To Help And Not To Rip You Off

I have a question about my car?

if you are unsure slow down a bit, no tyre is perfect, they all have a limit as to how much pain they can handle, even the bf goodies have limitations

1991 Saturn SC1 116,000 Every time I accelerate over 40 MPH the front of the car begins to stutter and shake?

I've never heard of Goodridge Tyres. I would get a quality name brand like BF Goodrich tires or Pirelli.
What you have sounds like a cheap knockoff or imposter.

Bad fuel pump?

your tyres are a mid quality brand, they will only complement your driving ability and cars road handling. any doubts ask another 911 pilot

Dash Lights coming on in my 2002 Buick Century. Any ideas?

http://www.cjtire.com/pdfs/tire%20identi...
Sounds like you want to go fast! If the tires are in good condition, one is about as good as another. Check the speed rating. The link above shows different speed ratings and MPH for each.

Does any one know how to get the key switch out?

If you want good cornering, go with Nitto, Toyo, or any other big name performance tire, and get wider wheels. You want wheels that are big enough to clear everything, but are as wide as possible, and match sizes in all ways front and rear for rotation abilities. Also, have your car lowered. A low center of gravity, and a large contact patch will allow you to go more than double the posted suggested speed. If it suggests 40 MPH, you could easily do 80 in a car that is completely stock. However, once lowered and given a wider (larger) contact patch, the car could possibly do 100+ around that particular turn, without so much as a wobble or squeel of the tires. But slowly increase your normal rate of speed areound corners you KNOW in order to get a feel for the vehicle's handling abilities. Caution: the lower the stance of the car, the firmer the springs need to be to prevent tire rub, and consequently, the rougher the ride when handling bumps and other road conditions.

Where can i buy seat covers, mats, and steering wheels covers for my car?

chack speed rating softness of tire etc go to performance tire shop they can tell you give you an idea of this most is on side of tire

How To Lower A Car?

If the tires have plenty of tread on them than use them until they wear down and then find out what was originally put on the car and replace them.
More Questions & Answers ...

  • Cost to put in air conditioning in to toyota echo?
  • 98 Blazer LT no spark! new coil, new ignition module?
  • 1988 Silverado question please?
  • Alternator Problems?
  • Attention ALL Gearheads! Is This The World's Smallest V8 Supercharged Engine You've Ever Seen?
  • There's a red light on in my car saying that my coolant level is low?
  • Ok my car doesnt have power locks, its a 2dr but can i get a keyless entry?
  • How much would it be to have a 1999 camaro hood completely sanded, primed, and painted?
  • Battery Cable fails on 2002 Dodge Grand Caravan ES - Now I need to replace entire wiring harness?
  • Where can I buy a rear gate for Infiniti QX4 1999?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.