Will a 168 tooth flywheel fit in my t5 bellhousing?

Question:
I am building an 86 camaro with an older engine. It had a 153 tooth flywheel in. Will I be able to fit a 168 tooth flywheel in a t5 bellhousing?

Answers:

My cadliac will not start because of the srs how do i by pass it?

i own a shop and as far as the bolt pattern goes it will bolt right up to it,and it should clear the bell housing also, but remember the starter issues with changing flywheels,it will make a difference in it,good luck hope this helps.

---

1999 BMW 528i Leaking Transmission Fluid...What to do?

the teeth on the flywheel are for the starter as for the size i think the sizes are different the one from the t5 is bigger but about 2inch just messure your old one and then messure the new if its not apart yet then ask your local parts store or speed shop

---

More Questions & Answers ...

What is wrong with my car?

Does a 5.0 jeep motor have a place for a dip stickl?

1995 Dodge Neon Transmission leak problem?

How do i take care of a car?

95 Montero 3.5 Engine Intake manifold question?

Fuel injectors, coil packs, 98 cavalier...oh my!?

Fuel gauge stuck?

Sunbird on the fritz...maybe?

2000 GMC Clutch slave cylinder on 5 speed manual. Does the tranny need to be pulled out to do this job?

What will a new suspension do for my 1998 Mercedes ML320 as far as performance?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.