Question:
Answers:
Hi,i have a question regarding water pump.?
I don't know about the '07 Suburban, but Chevrolet seems to be consistent in the way they engineer things, so it may work like my '03 S-10 :1) Open the hood
2) behind the upper cross-member there will be two L-shaped clips behind the headlamp area that simply pull up to release the headlamp assy.
3) Pull the clips up, and remove the headlamp assy
4) reverse the process to re-install - the alignment of the clips will be obvious once you have it out. Headlamps do not require alignment when removed in this manner
Hope this helps... Happy Hunting...!
Remove the 2 forward wheelhouse liner screws in order to access the hidden lower headlamp bolt.
Open the hood.
Remove the upper fascia bolts.
Remove the lower rear fascia bolt from the support bracket.
Loosen the 2 fascia to fender bolts from behind the wheelhouse liner.
Pull the outboard end of the front fascia straight outboard until it disengages from the fender attachment bracket.
Pull the fascia forward and downward to allow enough clearance to remove the headlamp assembly.
Remove the 2 upper headlamp bolts.
Grasp the headlamp at the upper inboard and lower outboard side and pull the headlamp forward to disengage the locating pins from the fender panel.
Pull the outboard side of the headlamp forward until the locating pin is disengaged from the radiator support.
Disconnect the electrical harness connector.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.