Question:
I need to find a website that has some comprehensive Ford tech data for current Ford engines, looking for 1996 Ford explorer 4.0L V6. Looking for head, intake, exhaust manifolds, sequence, and torQ spex, to re-assemble.
Answers:
Install and tighten cylinder head bolts in the sequence shown, in the following steps.
Step 1 — 30-35 Nm (22-26 lb-ft)
Step 2 — 70-75 Nm (52-56 lb-ft)
Step 3 — rotate bolts 90 degrees
Is the mercedes benz c 350 front wheel drive?
(5) (1) (3) (7)
Where can I find a good websites for mods on my car??
(6) (4) (2) (8)
If I just replaced the transmission in a 99 dodge ram Gas with the 5.9 liter?
The following is the torque spec. for the lower intake manifold:
Position the intake manifold with the aid of two guide studs located in position 3 and 4 below, and install the bolts hand-tight. Then remove the two guide studs and replace with bolts. Tighten the intake manifold bolts in three stages following the sequence shown.
Auto: Battery dies.. need help!?
8 Nm (6 lb-ft)
15 Nm (11 lb-ft)
22 Nm (16 lb-ft)
What is the best way to remove paint - from scraping a door - from a car?
(3) (5) (7) (2)
(1) (6) (8) (4)
BACK OF ENGINE-------------->
How do you know when to change tires on your car?
As for the exhaust manifolds:
Installation
What is the cheapest way to fix a leaky gas tank on my car?
NOTE: Lightly oil all bolt and stud threads before installation.
Is it really necessary to change the timing belt of a car's engine?
Clean mating surfaces on the exhaust manifold, cylinder head (6049) and exhaust inlet pipe (5246).
Position exhaust manifold on the cylinder head and install manifold attaching bolts. Tighten to 25 Nm (18 lb-ft).
2001 F-150 Will Not Shut Off With The Key?
Connect exhaust inlet pipe to the exhaust manifold. Tighten the attaching nuts to 27 Nm (20 lb-ft).
How do i change service indicator on my merc CD 200 2004.??
Hope this information helps.
How do one know when a fuel regulator goes bad in your car.?
You need to get a Haynes repair manual for your SUVOxygen sensor & catalytic converter replacement?
Try a company called alldata. A lot of auto repair shops use them inluding the one I work for. The program they have will give you all the information that you need about your vehicle or othr vehicles. You can also try going to your local parts store and buying a haynes or chiltons manual for your vehicle wither of them should also have all the information you need about your vehicleMore Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.