Question:
Answers:
I want to change timing belt on my vauxhall vectra any sugestions?
some have a nut to take off others you just have to get a screwdriver underneath the arm between the arm and cowl and pry it up off it's splines. Be sure to put a rag between the cowl and the screwdriver so you don't scratch your paint with the screwdriver.Where is the fuel filter located in a Mazda Protege 1994?
Small flat tipped screwdriver, lift the wiper arm untill it stops, slide the little flat pin thing over to lock the arm up, and release the lock from the wiper drive shaft thing.Jiggle and pull up.
Its kinda hard to explain if you're not right here. I assume you're talking about replacing the wipers, not removing the whole arm down to the cowl? The wipers attach to the arm on a small stud, its about 1/2 inch long. It fits into a hole on the wipers and will "snap" into place when you install it. To remove the blade you need to take the tension off the stud. Thats the "snap" you hear when you install them. Get a real small screwdriver, there is a small slot (square hole) in the top edge of the blade, above the stud. Insert the small screwdriver in the slot and push in gently, you should feel some tension and the plastic inside should give a little. While applying tension to the screwdriver (and the tab inside the blade) you can pull the blade off the arm. Its really simple but can cause a big headache if you've never done it. Sorry I couldn't explain it better. Hope this helps.
Car electric window repairs...?
you said before they have nuts on them Right?Removes the nuts fold the wiper up and jiggle it off
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.