Need Engine for a Yamaha 250cc (DS7). 1972?

Question:
A bearing went out on the top end around the piston pin only one side, But it damage the crank rod. Is there any way i can reem out the rod any tips on what i can do.
Thank's

Answers:

Steam from TailPipes in cold weather...?

other than haveing a time machine, you in a bad way, you may however still find some shop out there that has a new rod and bearing kit. your next step is to find someone to press out the rod and install the new one. the fit on the rod will not allow you to just ream it out. I have found it best to re-bearing the the crank mains also while you have it apart. I have owned a few 250's in the way backs .. good luck

---

More Questions & Answers ...

Intank fuel pump or Inline fuel pump? Which one is recommended. Do I need to upgrade? I will be boosting 6 psi

what course do i need to study to be able to restore cars ?

I smell anti-freeze in the cab of my truck. Steam also comes out of the vents. What could it be?

Do any aftermarket modifications improve mpg?

My 300 E Mercedez keeps stalling and shutting down?

89 Jeep Cherokee Batterie?

how much would it to replae the bumper?

1995 Geo Metro transmission slipping.?

Does anyone know how to adjust the camber in the front end of a 2000 Mazda B2500 two wheel drive pickup?

If there is air in my brake lines, will that cause me to lose brake fluid?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.