How do you take the back wheel off of a bicycle which has a stripped lug nut?

Question:


Answers:

Problem with 2000 Grand Jeep Cherokee Limited?

Pliers and a rubberband. Just wrap the rubberband around the lugnut tightly, and then use the pliers. If you can't find a rubberband, then try one of those rubber circle jar opener, or a piece of that foamy/rubbery stuff people put in their drawers or cabinets.

---

Battery Cable fails on 2002 Dodge Grand Caravan ES - Now I need to replace entire wiring harness?

Vise grips.

---

Problems with my '88 BMW 325i?

Try a lug or a nut cracking device but be careful not to penetrate to much and ruin the lug!!

Installed a 96 dohc ,was a 98 sohc,it wont run now ,what will make it run ?

Good Luck!!

---

How do I remove the trim rings from my wheels?

cut the nut off with a nut splitter or cold chisel

---

Oxygen sensor simulator as a diagnostic aid?

I'm assuming you mean the nut that holds the axle.
Good tools to have, unless the nut has been made round, are available at an auto parts store. Sure, you have to spend $10 but the tools last forever. They contact the middle of the flat side rather than the corners.

It's possible that a gasoline engine fonction without a spark?

There's always the small pipe wrench.

Car loan - blown engine? 2000 Dodge Intrepid?

Look on the inside of the bike mount...there may be an adjuster nut in there that you may be able to loosen and get the axle loose.

---

What is wrong with my car?

Since the nut is already rounded, use a pair of channel locks to get it off. Then buy a new nut and use a wrench to tighten it. The next time you need to get it off, it will be much easier.

---

My 2001 Intrigue has a bad smell (like something burning) after I've had it running a few minutes...?

vise grips and some muscle

---

My engine light came on?

Have you tryed a vice grip plyers?

---

Are these the same tires?

good pair of vise grips with curved jaws for the best grip. That nut was probably overtighted with the wrong wrench most likely a cresent, they don't call them knuckle busters for nothing

---

More Questions & Answers ...

98 Chevy Malibu, the emergency break light in my car won't go off. Whats wrong?

Where can I find a kit to rebuild a distributor for a 1991 colt?

What is the best way to clean rust off of full 100 gallon propane tank and painting it?

How offen do I need to change my oil on a new Volvo?

Car Alternator I have a Ford Crown Victoria 1995?

What coolant do I use in a 1996 nissan pulsar sss ??

How to replace car thermostat?

I have a 6 hp kohler engine that keeps fouling the sparkplug. Why and what can be done to fix this problem?

Oil on my engine?

1988Chevy truck 350,what is the "CFM"on the throttle body?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.