Can you bolt a 6-pack carburetor setup onto a smaller Mopar engine such as a 361, 383, or a 318?

Question:


Answers:

How often should I get my tires rotated and balanced?

as long as you have the correct manifold for that type block :)

---

How much should it typically cost for a timing belt repair?

Probably but you might get the same performance with less headaches by just using a high CFM 4bbl. 6 packs can be hard to synchronize.

---

How are people that work in new car dealership auto shops paid? What are flag hours?

You can if you get big valve heads.... it wouldnt do any good to stick a 6 pack on with small valve heads.

---

My transmission makes a deep sounding clunk noise when I change from P to D and from D to R?

so far all good answers. they right intake manifold is needed, the proper linkage is needed too. then synchronizing the carbs is the hard part. all for not if the engine can't handle to carburetion.

---

More Questions & Answers ...

i have a 1989 2.3L ford mustang lx. i want to convert it to a 5.0L. what do i need to do?

When i press down on the brakes in my 2001 Daewoo Leganza they push back at me and grind, What is this!?

ck enigne light came on ,on my '99 dodge 1/2 ton truck, had it ck'd out shows the catalictic elec. below

Do I need to get the halogen level checked for my headlights?

where can i find hinges for roll up door for cube van in michigan?

Where can I get a ignition key for my 1988 AMC Eagle?

would my car be loud by by passing the catalyac converter?

96 Jeep Grand Cherokee 4.0 motor and auto trans shifts ok when cold but when gets warm 2nd to 3rd is slow?

Why do I always need to top off my radiator?

Speed sensor, I think, on a Volkswagen?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.