Clutch, Headgasket New car?

Question:
------------------------------...

tanny change?

Hey

Why won't my car start when it's really cold?

Had my 00 impreza RS for a few years now and its got 82 thousand miles. I am planning to replace exhaust and suspension. But when I took it into the garage they saw that the right head gasket was slightly leaking and the other one was pretty much fine. Just wondered if this is going to be a major issue? I have no power loss and haven't found any water/ oil on the floor. Do RS this age Head gaskets go aound this age? I haven't raced or ragged the car. Anyway the HG job will cost 2 grand apparently, also to make matters worse the clutch is slipping under acceleration so thats done. I was wondering which aftermarket clutch is good, obvious aint got major cash with all these bills but the stock exedy clutch is blantely Sh!t with everyone with an RS suffering clutch judder especially when its cold.

Where does the thermostat go in a 1989 4-cyl Dodge Dakota? Also install tips please?

Everything with Labor prob cost like 5 grand so do u think I should get a WRX

Answers:

How do I change the ignition switch on my 1993 chevy corsica? serious answers only please!?

I would advise you to sell it if you dont have the money to cover the costs

---

if a car with a 40l petrol tank which equals229.17kJ of energyuses it at a rate of 20kW, how long will it last

that's the trouble with Subaru when they do go wrong its expensive to fix 82 thou you say i would think about replacing for a newer model! regarding your clutch Borg and beck do a decent after market clutch also have flywheel checked as this may cause your clutch judder problem

---

If you accidentally put diesel fuel in you car what will happen?

compression test will show if head gasket is faulty in sealing ring areas if it's just dribbling from outer edge it's not a vital area but it wont improve with age clutch judder is normaly caused by defective assembly or a scored or distorted flywheel these must be ground (not machined) on a special lathe to recover (a centre lathe cannot mount this accurately enough with ref to drive flange)

---

My van sliding doors freeze shut all the time, does anyone know of a product to prevent this from happening?

yes and a different mechanic or at least a second oppinion.

---

More Questions & Answers ...

where can i buy a replacement mirror- just the glass part- for a 1993 ford ranger?

my 2001 ford f-250 supercab has a remote that wont lock or unlock even after a new battery what can be done?

My 1987 Mustang 5.0's starter keeps running even with the ignition off?

my e mill is blocked i didn't get any em ill how can i fix the prob lam?

Timing belt vs. Timing Chain. which is better?

Gear won't shift my 1995 camry?

What causes a thumping/knocking noise when I turn left in a 2000 Ford Focus?

Where is the starter on a 1998 Ford Windstar?

engine swap 97 3.9L to 2000 5.9L?

auto question: I always see air filter bolt ons saying they add 20 horespower.?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.