Question:
So whats the best way to seal the ignition system?
Answers:
Exhaust problems on a 2001 Ford Explorer Sport?
When i was biking i used to use ignition sealant.Halfords/Motorsave/Cha... Browns anywhere like that sell it,about £2.50 a spray can.I then sprayed everything i.e. plug caps,ht leads,battery terminals,coil etc.When dry after about 30mins it forms a clear plastic film over where you have sprayed.My bike (Honda cx500)would then run in anything typhoons,blizzards,earthquakes... storms etc.You name it,that bike would plough through it.Hope this helps.how to dicsonnect the speed governor on an s-10?
the simplest a arguably the best solution is to spray WD-40 all over any and all electrical components regularly , it cheap but very effective , also make sure your air filter is not to exposed as it is common for people to upgrade to K&N or similar which protude further than the original and so get wet thus sucking water into the carb when the bike is started .More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.