Idle pulley still making noise even new..?

Question:
i replace my idler pulley because of the noise that it was making.. now the 2nd one still makes noise... what can i do to get rid of this noise.. i know its the pulley because when sprayed with WD40 it goes away..

Answers:

Moped broken...?

I had this problem with a Peugeot diesel car.

Why do vehicle batteries need to be greased before they are installed?

I thought replacing it would make the noise go away and it didn't. I replaced it several times (not a cheap thing to do) and the noise always came back.

How do you adjust the headlights on a 1998 gmc yukon?

The garage (who I trusted) said that because the pulley had come loose over time, it had made some sort of groove on the surrounding mechanics and so, short of replacing the whole area of engine - the noise would always remain.

Is an Isuzu Rodeo the same as a honda passport?

Also, this looseness in the area because of the initial pulley becoming faulty (and me not knowing until the noise got bad) meant that the subsequent pulleys I replaced it with would have a limited life.

What does the little snow flake mean?

My advice - put up with the noise, or fix it and sell it very very quickly. I had mine for ages after it initially went - I ran a taxi cab company and it was a great car.

---

Hi everyone,needing a smart anwser to a transmission question?

i believe they have some belt tensioner spray or some belt spray at your local parts store, try that

---

PUG306 , 51reg cabbie,dials frozen, fuel & no lcd trip.?

Hmmm, something is fishy. Part of the problem may be that it is not properly aligned and therefore making the noise. Try putting a washer on the bolt to act as a spacer and see if that helps any. Also when the engine is running look at the other pulleys and see if they are running smooth. Possibility that one of them is crooked causing the idle pulley to squeak cuz it is pulling the belt at an angle.

How much limit is there to the amount of octane that I can put into my car?

Try this troubleshooting guide from Auto Zone for a 2000 truck. All the problems and fixes would basically be the same for any vehicle. Or put yours in and then go to the troubleshooting guide.
http://www.autozone.com/servlet/uibroker...

---

More Questions & Answers ...

Rear rim won't come off of the hub?

Car troubles.?

Hi could anyone tell me where the cold start needle/valve is on an escort xr3i mk5?

Loose Vacuum Hose?

Does it matter what material you use to replace a sagging headliner?

How much does it cost to fix the gas gauge?

95 ford ranger w/ check engine lite on codes p1401,p1443,p0402,what are the codes for? how do i fix them?

My serpentine/fan belt is squealing; how do i make it stop?

Gear box gone ... already?!!?

My camry is comepletly locked! Please HELP!!? - not the weel!!?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.