What is the torque spec for a 1988 dakota tie rod end nut?

Question:
I just replaced the rack and pinion and the tie-rods. My question is how tight to torque them and how to bleed the system when all hooked up? Another question would be the thread count on one side was 8 and the other side was 16. Now when I put it all back together that is obviously way off, so now it appears I'm going to have to eyeball it and take it in for an alignment (or more). Thanks for the help.

Answers:

How do i clean my air filter?

http://www.rockfordcv.com/chrysler_torqu...
More Questions & Answers ...

  • body shop work can i buy the parts?
  • I purchased fog lights but dont know how to install them. who do I have install them?
  • 96 jeep grand cherokee with non functioning trailer lights?
  • My Ford Falcon EB transmission(auto)wont work in reverse.?
  • What gives?!?!?
  • Is there a Renault laguna diognostic tool?
  • 79 Chevy suburban I'm going to buy a new tail gate from junk yard how do I hook a battery up to it to see?
  • changing lights in 94 taurus?
  • What all design defects have you noticed in vehicles in your experience with them?
  • what performance parts can ya get for diesel's?

    • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.