Toyota Corolla 93 brakes padles got too soft and not work properly?

Question:
i just changed all four brakes and front rotors less than 500 Km ago. today, suddendly the brake padles becomes too soft and brakes does not work properly...
also hand brakes light is continously on, however brake is not active.
what could be the problem please help thanks

Answers:

Parking sensor?

u have to check the break oil , it is very common, just refill the oil

---

Vehichle recently vandalized with paintballs that are oil based?

Check your brake fluid.

---

Why does my truck have a rough idle?

the master cylinder gave up.

@ 65,000 miles,what service do i do on a `04 pilot ?

or You have a leak some where.

---

Is this car good for racing?

you have air in the brake system. THIS IS VERY DANGEROUS and you need to "bleed" the system IMMEDIATELY and do not drive the vehicle until you get this done. the spongy pedal is an earmark sign of this.

How often do a car's ball bearings need to be replaced?

did you bleed the brakes with your brake job? this is an integral part of any brake job.

How do i replace 1997 ford explorer xlt license plate lights?

with air in the system your brakes WILL FAIL it is only a matter of time.

---

My second cylinder is striped is there anything i can do to fix this? Thanks?

Did you thoroughly bleed the brakes when you changed out everything. It is possible you got air in the system, especially if you took any hoses off or loosened any lines. There is a specific procedure for each vehicle, so see If you can borrow or web Search directions.

---

More Questions & Answers ...

How should I mount this carbon fiber muffler?

Does the Hyundia Sonata 1999 come fitted with an immobilizer ? cann't start my car !?

About cars?

I have a 1991 Honda Accord EX and the idle is running very low and sometimes it stalls.?

What are some signs your vehicle would need an alignment check?

How do i change out my cv axles on my 1992 mitsubishi 3000 gt?

Changing brake pads 2005 Ford 500?

Vauhall Vactra?

When your car is at a complete stop, the RPM meter should read zero, right?

How to fix a car that's been keyed?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.