I have a 1995 4runner 4wd/6cyln. the oil pressure gauge has gone out. any suggestions? motors fine?

Question:


Answers:

Is FLOATING the gears of a manual transmission vehicle "stick shift" good or bad please explain why?

i own a repair shop,and its probably just the sending unit on it that's gone bad,,if its running fine,then it has oil pressure ,id replace it first ,,since its the easiest ,and cheapest to repair,,good luck,hope this help,s.,have a good x-mas.

How do I replace the Key Ignition on my Plymouth Voyager?

check and see if theres power goin to it. if not replace. if so, oil pressures goin. worthless then. i had a car that ran fine, guage went still ran fine. so of course, if it aint broke dont fix it. sike! every seal in the motor went.

starting deisel engine?

you may need to check the oil pressure sending unit before replacing gauge

FUEL INJECTOR AND CARBOURATOR Cleaner, is this good for your car?

install a mechanical gauge you will have no worrys after doing so

1994 Pontiac Grand Prix GTP Key Chip?

get a new gauge if the motros fine duhhh
More Questions & Answers ...

  • do I have to invest to much money to start a diesel garage?
  • how do you mount go kart tires on the rim?
  • does stop leak work?
  • What is wrong with my car?
  • what type of oil should I use for my car (VW Lupo)?
  • Are there any good Garage door remotes?
  • heater doesnt work?
  • In what order do I disconnect my battery cables on my Ford Explorer? Positive or negative first? Also...?
  • Honda Civic timing belt replacement in Dallas?
  • L REG CLIO 1400CC wiper work but front screen wash and rear wash and wiper does not?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.