How do I get my 1996 mazda 626 motor low enough to remove to crankcase pully?

Question:
I have removed the passenger front motor mount and still I cant get the motor low enough to remove the crank case pully all I need is 3 more inches.........

Answers:

Why does the message board say, "see ice" on a Buick Rendezvous?

Don't know what kind of engine, or subframe layout, but you could try LOOSENING (not removing) another engine mount or two, WITH A JACK SUPPORTING THE BOTTOM OF THE ENGINE.

---

My van sliding doors freeze shut all the time, does anyone know of a product to prevent this from happening?

Put a jack under your engine. Use a flat piece of wood and put it between the jack and the oil pan.Which is where you'll put the jack. Remove the front motor mount or mounts and have the jack already putting some upward force on the engine slowly lower the engine. If it doesn't get low enough you may have to remove the other motor mounts too. When you install the pulley again all you should have to do is jack up the engine and reinstall the mounts you took off.

---

More Questions & Answers ...

My power steering is very loud, can I fix it?

Damage to car bodywork?

my jeep slips into neutral while i'm driving in two or four wheel drive. transfercase?

white smoke comes out of the exhaust on my suv when i start it cold. what could be the problem?

I want a small R.V. with a diesal engine for best mileage, any suggestions?

raditor fan not working?

Timing Chain slips after side impact crash?

Trans Am Repainting?

Car problem?

Can I mix two different types of synthetic motor oil?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.