Tranny fluid for mopar..?

Question:
my car is pretty low on atf tranny fluid and it says to use mopar atf 7176. I cant find 7176 anywhere. is chrysler atf+3 the same thing as 7176? i can find that or this mecron ford crap.

Answers:

Why won't my high beams go off even when I turn off the engine on my 97 ford crown vic?

Do not mix ATF fluids. Mopar ATF 7176 is a Chrysler spec. Sometimes you have to read the entire label on the back of an ATF container to find the info you need. Go to a Dodge or Chrysler dealership and buy it there if you can't find ity amywhere else.

---

If a car has 130,000 highway miles on it, is that bad?

type F will make it shift firmer..delcron will make it slip more.
if you buy a trans from B&M they recomend type F

---

Why does our cavalier consume so much fuel?

How old is the car?
The "7176" may be a Chrysler number that qualifies the engineering of the oil. If you can locate it, use the ATF+4. It will perform well in ALL Mopar transmissions, even the very old 727s.

---

More Questions & Answers ...

How do I get cigarette smell out of a new car?

What's exactly done and what things get replaced in a tune up?

What to do with a dead car?

Just gotten a wheel alignment done but vehicle stills pull right. what could be wrong?

Why does my drive shaft keep braking?

Alternator and battery both good, car won't start?

My cars doent stay on when is not warm?

Body Shop Question?

Repair Question. Ford F150 Bearings?

Engine Help?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.