On a gm pickup the brake peddle to the Flore. put new master cylinder on?

Question:


Answers:

How can i remove a build up of wax from my black car bumpers?

Master cylinder possibly booster.

I want to get a cold air intake for my 06 mustang GT... which brand and modle are most fit ?

You didn't like the answer the first time you asked? Is that why you asked again?

Why are abandoned gas stations painted dark gray?

bleed the brakes.you shouldnt need a new master.it sounds like there is air in the line

Pt cruiser problems?

your not giving enough details. If you are saying your brake peddle is going to the floor, Then it could be a few things. If your losing break fluid then your master cylinder could be bad. If your now losing break fluid, I would check your power brake booster.

Should I take the insurance money?

did you bench bleed the cyl. before installing??Check brake calipers/pads. If pads are worn all the way down the piston in the caliper will be fully extended causing excessive pedal travel

How to repair ragtops?

Check the fluid level first, see if there's any there. If there is fluid but no pressure then it's the master cylinder.

Car won't turn on unless jumped, battery and alternator tested fine at Sears, 03 Taurus. What is the problem?


The booster can make the pedal hard, but not soft, well not softer than it's supposed to be.

How to test the car air conditioner in the cold weather?


If the fluid is missing then you are going to need to search for where it's going. The answer will be one of the slave cylinders, a broken line, or through bad seals and into the engine through the vacuum booster.

Oldsmobile alero starting problems?

it could be a couple of things , your brake line might have a leak or your master cylinder when replaced did not have the air removed prior to install or you might need to add brake fluid and bleed the system to raise the pressure in the master cylinder, if all of this has been checked and or done check your brake shoes and pads. if they are good also check the cylinders of the rear brakes, they might have gone bad and are starting to leak or have stopped working altogether. might also be the preportioning valve going out which is under the master cylinder.
More Questions & Answers ...

  • A question about a egr valve?
  • Major oil leak issue help after oil change from dearler?
  • When should I replace my car battery ?
  • 1988 Silverado question please?
  • I just got a 98 ford mustang, V6 3.8l and it sounds bad, whats a good deep sounding and semi cheap exhaust??
  • Will low voltage damage a 12 volt dc motor?
  • I have a SAAB 93 convertable (2001 model) Tyre noise is terrible. fitted Michelin Premacy 195/65, any ideas?
  • I have a small case of oxidation on the top of my car, any suggestions?
  • 1990 s-10 blazer fuel problem?
  • Where to find interior light fuse in a 1992 saturn?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.