Question:
I HAVE A 04 STI AND MY TURN SIGNALS HAVE SLOW STARTED TO SLOW DOWN. HOW DO I CHANGE THE FLUID?
Answers:
I have a 1986 Mercedes 560sl. It takes time to start. The ABS light and O2 sensor light are on?
remove left outer signal. be careful not to break the cover. Park car on a hill and drain the fluid. Put cover back on when it stops draining. Remove turn signal switch, park car on a right incline so the signal hole is facing up. Pour in liquid turn signal filler found at any parts store. If you can't find any ask the attendent.can a chevy 350 engine work in my ford ranger will my tranny bolt to the engine?
Don't fight the police when they are putting you in the ambulance to go to the Physc ward at the hospital. Oh by the way, engage your emergnecy brake before parking on a hill or you might have to call the police before the Parts Store does and you won't get the fluid changed.
1993 GMC Safari Van Rattling going over bumps?
you might want to look in the reservoir in the alternator, the fluid might be low in there too. i suggest you go to autozone and ask for the fluid since they only carry it behind the counter. hope this helps. while you're changing the fluid, you might as well check the condition of the bearings in the handle.Which cars have the quickest estimted time for head gasket replacements?
STI's have a cap below and to the right of the passenger headlight beside the headlight fluid resevoir. Do not overfill otherwise it will cause too much pressure and damage the bulbs.My car is leaking oil bad What can I do??
the turn single fluid cylinder is located under the car right beside the container that holds all of the muffler bearingsI have a 75 Nova Custom. I'm trying to swap to a 454 bbc. What kind of engine mounts should I use?
Heck just operate your turn signals manually. You can blink them as fast as you want to then. If it's that important to you though, I believe your best bet would be to drill a hole through your crank case to release your indicator fluid. For some reason this is the way the Pollock's designed the system. Stick some bubble gum in the hole you drilled when the fluid has drained and refill with indicator syrup. Check the air pressure on your rear passengers side tire and when you can get it up to 100psi your turn signals should operate at 758 blinks per minute.Never heard of fluid for a turn signal.
The 4x4 on my 1996 dodge ram 1500 is out, any idea's?
When the turn signals flash too slow or too fast, it usually means you need a new flash unit. These are usually located around the fuse block. They're mostly round and often are covered with aluminum or plastic cases. About $3 to $9 and an easy DIY fix.
Don't listen to all the smart*** coments if youre serious then you may need a bulb,flasher unit or a turn signal switch. There is no such thing as blinker fluid,muffler bearings or anything like that.
More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.