Question:
So where is it located? Is it external easily seen or is it inside the transmission?
Answers:
Why do I need to have my brake fluid flushed? And how often should this be done?
It depends on the vehicle in question. You didn't state the year, make, or model of the vehicle you are referring to. Some are mounted externally on the transmission bellhousing, as others have already suggested. On some other models it may be a "concentric" type slave cylinder, which requires transmission removal to access. Hope this helps.1995 gmc jimmy having a hard time starting?
Clutch slave cylinder is on the side of the bellhousing, drivers side under the car.Looks kind of like this.http://www.uneedapart.com/used_auto_part...
How do i install my new alternator for my 1993 toyota camry?
It is external (on 98% of all cars except some weird Saabs) usually on the side of the bell housing, just behind the engine, on the driver's side. The bell housing houses your clutch, so it's between the engine and the transmission.Anyone Know recommended tyre pressures for Ford Ranger?
your slave cyl is at the opposite end of the clutch master clyHow good are the Electronic Rust protection devices compared to traditional solutions?
usually right next to the clutch housing, there will be a hydraulic line coming out of it
96 Ford F350 with Power Stroke.?
its externally located. i think its on the side of the tranny by the linkage(been a while since i checked one or owned a standard). may be under the hood.my memory is foggy right now. i know it isnt in the tranny though!Whats wrong with my olds alero?
In most cases, the slave cylinder is located just outside the transmission. It's purpose is to actuate the clutch release bearing assembly. The slave cylincer acts as direction of motion changing device. They are simple cylinders with only a couple of seals and a dust cover. The system must be bled of all air after servicing as is the case with any hydraulic system.Does leaving a car cell phone charger in your dashboard lighter drain your car's battery?
There are some Cars Which house the slave cly. inside the bellhousing as a part of the release bearing assembly. But Alot of newer cars have them in various locations check your owners Manual Or A Repair Manual For Your Make & Model Would Be Better.How do you push-jump start a car with a stick shift?
It depends on make and model. Some cars and SUVs have a slave cylinder and throwout bearing combined and some have the slave cylinder mounted externally on the bell housing.More Questions & Answers ...
This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.
Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.