Why won't tranny on 92 econoline shift out of low without letting up on gas?

Question:
When it does shift, it goes up thru the gears too fast. Does the shifting work with the vaccuum?

Answers:

my NO emmisions rose from 800 ppm to 1200 ppm after I installed a new EGR. Why?

This transmission does use vaccuum to shift. Your problem could be in a vaccuum line or the "shift modulator". This could also be because the filter aned fluid need changing. If this is the case, take it somewhere and have it flushed too.

Mondeo year 2000 Lights?

i own a repair shop,and ford hasn't used vacuum to shift there transmissions in a long time now,,this one is controlled by a cable and the valve body,,it probably just needs a good filter and fluid change done on it right now,,its not picking up the fluid fast enough to enter the transmission,and this is causing it to not shift right,,have it changed ,and have the bands adjusted while your at it,,and it will shift a lot better ,good luck hope this help,s.,,have a good x-mas.

When my car is in park the engine starts to overheat when i drive the engine cools too much what could that be

dodge man has it right
one thing to keep in mind with that system is dont mat the throttle really quick in cold weather,this will cause the adjustment to jump again

Re my previous question please note info should read 1998 Rav 4 not 1988?

dodgeman is right and the guy below him is could be right too. I would like to add the the throttle valve cable could be broken or could be disconnected from the throttle because of a broken plastic clip that holds it to the throttle. I know the wording is a little off but I hope you can understand it.
More Questions & Answers ...

  • Is it expensive to fix a serpentine belt?
  • Is a quadrajet carb a square bore or spread bore??
  • How do I change the right rear hub assembly on my 2002 Ford Explorer XLT 4 Wheel drive?
  • what is the cost to have a 1992 honda accord LX auto transmission rebuilt?
  • what is the name of the big pulley that is attached to your camshaft?
  • What's the typical hourly rate for labor in the midwest (USA metro area)?
  • new car(Sienna 2006) dead battery?
  • Can anyone tell me how to put a new door knob on?
  • Western snowplow will not lift or tilt?
  • Whats the best way to seal T-top rubbers from rain drips on a 300Z? Vaseline? Or other ideas.?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.