Mechanic needed?

Question:
i have a 98 caviler and whould like to know where the tremostat is located

What is the diffrence between the 1990 13b rotery and a 1993 13b rotery?


i also have an older ford ranger how do you bleed the cluch?

Check engine light wont turn off?



thanks
austin

Answers:

How can I identify the power steering resevoir?

It's hard to get to, but if you look at the front of the engine it is beneath the intake manifold (2.4). It is right on the block, and if you don't like tight places, it's not the job for you. It is right on the front of the block, above your oil filter etc.

i cant get the alignment motor to work after i replaced both headlamps?


As far as the clutch on the ranger, depending on the year the location varies. You should have a small reservoir on the firewall, that is for the clutch slave cylinder. If the reservoir is empty then it most likely has a leak somewhere, most commonly on the slave cylinder it'self. The slave cylinder is located usually on the side of the transmission and it attached to the clutch fork end. The slave cylinder is not a complex or terribly expensive part to replace.

My car won't move out of "park" '95 Merc Sable?


The procedure to bleed it is the same as bleeding brakes, make sure the reservoir is full, replace the cap, pump up the clutch a few times and then release the bleeder screw on the slave cylinder. It is much easier to do this with two people. Repeat the steps until the clutch pressure is firm. Making sure that you keep the clutch slave cylinder reservoir full the whole time you are bleeding it, and you tighten the bleeder screw when finished.

What's the best way to insert the trans. dipstick tube after installing the trans.?


Try and locate a Haynes or a Chilton manual for you year Ranger, it will walk you through it step by step.

Does Sears Auto Center do wheel alignments? If so, about how much does it cost?


Good Luck

A mechanic forgot to put the coolant cap on my car. It over heated and is ruined. What should he do?

Remove top radiator hose thermastate is located in the block. Don't know about the clutch.
More Questions & Answers ...

  • My car defrost air stays cold unless I race the engine, or after I start moving. Help, what is wrong?
  • My car is broken! Can anyone tell me where to find an online diagram, so i can diagnose this problem?
  • I bet nobody can answer this one!!! what takes diesel exhaust off the side of my trailer?
  • Battery Problem?
  • 50% engine compression?
  • The paint on my car's hood is faded very badly- is there a polish or wax that I can use to make it shine?
  • Pro-m mass air info needed?
  • What could be wrong with my car?
  • How can you tell if your car is misfiring?
  • 91 blazer can not diagnose?
  • This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.


    Copyright 2006-2008-2007 CarQnA.com. All Rights Reserved.