Anyone know how to take off a shimmy shock ?

Question:
1976 Monte Carlo, I have a rotten shimmy shock. This shock is on the steering to the frame. The end on the frame i got off, but the other end i am having trouble. There is a long bolt going through the shock and through the the steering bar. On one end there is a cotter pin and a nut, i got it off. Then just on the other side of the steering bar on the bolt is a nut as well it might be part of the bolt i dunno. I managed to pull the shock off as the end was rotten. How do I get the whole big bolt out. Do i need a pickle fork or what about putting a 3/4 deep socket and a air gun. Help me out as i am stuck thanks,

Answers:

Problem with my car repair!?

use a socket and air impact wrench.The end that the castel nut was on has a taper like a tie rod end.

---

1995 gmc jimmy 4.3 vortec engine having a hard time starting. Fuel problem?

Try taking a large pair vice grips and clamping the shock to the steering bar. The bolt that goes through the shock is tapered so clamping it down may lock it in place. If that doesn't work you can try using a pickle fork.

---

More Questions & Answers ...

5 w 20 VS 5 w30 motor oils?

Parking sensor?

Door won't open - I have to have it open for repair - How do I get it open?

Brake pads?

I have serious paint oxydization on an old car, is there anything to make it shine again?

Why does my range rover keep blowing the pipe from the air flow metre to the plenum chamber.?

I seem to be losing gas mileage. Also I have been noticing the smell of gasoline outside my vehicle.?

How to get broken pipe fitting out?

What can I wrap around my starter to protect it from heat?

Timing chain problems. with 87' Ford club wagon?

This article contents is post by this website user, CarQnA.com doesn't promise its accuracy.